Single path barrier Dimensions UBE500-F64-SE2-V3 25 17 40 12 ø 3.5 32 LED 18 Features • Reliable detection of transparent materials ø 24 • High switching frequency • Small angle of divergence • Small, compact design Technische Technical data Daten • Plastic housing • Transmitter and receiver included in the delivery package Electrical connection General specifications Sensing range Reference target Transducer frequency Standard conformity Indicating/Operating means LED yellow Electrical specifications Rated operational voltage Ue No-load supply current I0 Output Output type Rated operational current Ie Voltage drop Ud Switching frequency f Switch-on delay ton Ambient conditions Ambient temperature Storage temperature Mechanical specifications Protection degree Connection type Material Housing Mass 0 ... 500 mm, distance emitter-receiver 15 mm ... 500 mm Receiver 200 kHz EN 60947-5-2 switching state switch output 10 ... 30 V DC, ripple 10 %SS 20 mA Receiver 12 mA emitter 1 switch output E2, pnp NO 200 mA ≤2V 100 Hz < 5 ms 0 ... +60 °C (273 ... 333 K) -40 ... +85 °C (233 ... 358 K) IP54 V3 connector (M8 x 1), 3 pin PA 6.6 80 g each sensor Standard symbol/Connection: Receiver: 1 +UB 4 3 106184_e U -UB Emitter: 1 +UB U -UB Subject to reasonable modifications due to technical advances. 3 15.08.2001 3 Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com Note Hinweise Model number UBE500-F64-SE2-V3 Function A through-beam ultrasonic barrier always consists of a single transmitter and a single receiver. The function of a through-beam ultrasonic barrier is based in the interruption of the sound transmission to the receiver by the object to be detected. The transmitter sends an ultrasonic signal that is evaluated by the receiver. If the signal is interrupted or muted by the object to be detected, the receiver switches. No electrical connections are required between the transmitter and receiver. The function of through-beam ultrasonic barriers is not dependent on the position of their installation. We recommend, however, to install the transmitter below in the case of vertical installations to prevent the accumulation of dust particles. Characteristic curves/ Additional information Characteristic response curves 90 80 70 60 50 40 30 Angle [degrees] 20 Installation tolerances: 10 The installation tolerances of the central axes of the transmitter and receiver may not exceed the values specified in the illustration. 0 0.0 Detection of thin foils 0.1 For the detection of thin foils (< 0.1 mm), install the through-beam ultrasonic barrier at an angle of > 10° from perpendicular to the foil. 0.2 -10 -20 0.3 Distance [m] 0.4 0.5 0.6 0.7 α Mounting/Adjustment α A Parallel displacement A ≤ 8 mm Angle displacement α ≤ 5˚ ≥10˚ Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com 4