Part Number: www.SunLED.com ZFMOK05A SURFACE MOUNT DISPLAY Features ● 0.21 INCH DIGIT HEIGHT. ● LOW CURRENT OPERATION. ● EXCELLENT CHARACTER APPEARANCE. ● I.C. COMPATIBLE. ● MECHANICALLY RUGGED. ● GRAY FACE,WHITE SEGMENT. ● PACKAGE : 650 PCS / REEL. ●MOISTURE SENSITIVITY LEVEL : LEVEL 4. ● RoHS COMPLIANT. Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ± 0.25(0.01") unless otherwise noted. Operating Characteristics (TA=25°C) 3.The gap between the reflector and PCB shall not exceed 0.25mm. 4.Specifications are subject to change without notice. Absolute Maximum Ratings (TA=25°C) MOK (InGaAlP) Unit Forward Voltage (Typ.) (IF=10mA) VF 2.0 V MOK (InGaAlP) Unit Forward Voltage (Max.) (IF=10mA) VF 2.5 V Reverse Current (Max.) (VR=5V) IR 10 uA Reverse Voltage VR 5 V Forward Current IF 30 mA λP 610 nm Forward Current (Peak) 1/10 Duty Cycle 0.1ms Pulse Width Wavelength of Peak Emission (Typ.) (IF=10mA) iFS 195 mA λD 601 nm Power Dissipation PT 75 mW Wavelength of Dominant Emission (Typ.) (IF=10mA) Operating Temperature TA -40 ~ +85 Spectral Line Full Width At Half-Maximum (Typ.) (IF=10mA) Δλ 29 nm Capacitance (Typ.) (VF=0V, f=1MHz) C 15 pF °C Storage Temperature Part Number ZFMOK05A Tstg Emitting Color Orange Published Date : FEB 28. 2008 -40 ~ +85 Emitting Material InGaAlP Luminous Intensity (IF=10mA) ucd min. typ. 8000 37190 Drawing No : SDSA5285 Wavelength nm λP Description 610 Common Anode. Rt. Hand Decimal V2 Checked : Shin Chi P.1/4 Part Number: www.SunLED.com ZFMOK05A SURFACE MOUNT DISPLAY MOK Remarks: If special sorting is required (e.g. binning based on forward voltage, Luminous intensity / luminous flux, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity / Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. Published Date : FEB 28. 2008 Drawing No : SDSA5285 V2 Checked : Shin Chi P.2/4 Part Number: www.SunLED.com ZFMOK05A SURFACE MOUNT DISPLAY Recommended Soldering Pattern (Units : mm;Tolerance: ± 0.15) Tape Specification (Units : mm) Published Date : FEB 28. 2008 Drawing No : SDSA5285 V2 Checked : Shin Chi P.3/4 Part Number: www.SunLED.com SURFACE MOUNT DISPLAY PACKING & LABEL SPECIFICATIONS Published Date : FEB 28. 2008 ZFMOK05A ZFMOK05A Drawing No : SDSA5285 V2 Checked : Shin Chi P.4/4