Oscilent Corporation RF SAW Filter | 802-RF947.5M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 802-RF947.5M-A 3.0 x 3.0 SMD GSM System Feb. 04 2003 . TYPE : 947.5 MHz RF SAW Filter PART NUMBER : 802-RF947.5M-A . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 947.5 - MHz 935.0 ~ 960.0 MHz - 2.6 3.5 dB DC Voltage - - - 5 V Input Power - - - 15 dBm Operating Temperature - -30 - +85 °C Storage Temperature - -40 - +85 °C Center Frequency Insertion Loss Ripple Stopband Attenuation 935.0 ~ 960.0 MHz - 0.9 1.5 dB DC ~ 870.0MHz 25.0 30.0 - dB 870.0 ~ 915.0 MHz 30.0 35.0 - 980.0 ~ 985.0 MHz 20.0 25.0 - 985.0 ~ 1025.0 MHz 30.0 37.0 - 1025.0 ~ 1500.0 MHz 28.0 34.0 - 1500.0 ~ 2000.0 MHz 30.0 38.0 - 935.0 ~ 960.0 MHz - 2.1 2.5 - Source Impedance Single Ended - 50 - ohm Load Impedance Single Ended - 50 - ohm - - 50 - ohm VSWR Teminating Impedance * Maximum Rating (Ta=25°C) ** Custom SAW RF Filters available. Contact Oscilent for assistance. . Pin Layout A Ground B Output C Ground D Ground E Input F Ground Frequency Reponse http://www.oscilent.com/spec_pages/rf_sawfilter/rf_802_rf947_5a.htm 12/28/2005 Oscilent Corporation RF SAW Filter | 802-RF947.5M-A Page 2 of 2 VSWR (S11, S22) Smith Chart Oscilent Corporation - CALL 949.252.0522 17962 Sky Park Circle . Building D . Irvine . CA 92614 . USA Fax: 949.252.0599 . E-Mail: [email protected] Part No.: 802-RF947.5M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/rf_sawfilter/rf_802_rf947_5a.htm 12/28/2005