Oscilent Corporation RF SAW Filter | 802-RF448.0M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 802-RF448.0M-A 3.0 x 3.0 SMD Wireless Communication Oct 01 2007 TYPE : 448.0 MHz RF SAW Filter PART NUMBER : 802-RF448.0M-A OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 448.0 - MHz Insertion Loss 446.0 ~ 450.0 MHz - 2.6 3.2 dB Ripple 446.0 ~ 450.0 MHz - 0.5 1.5 dB Fo -200.0 ~ Fo -60.0 MHz 50.0 55.0 - dB Fo +42.8 ~ Fo +200.0 MHz 50.0 55.0 - - - 150/0 - Center Frequency (Fo) Stopband Attenuation Teminating Impedance ohm/pF * Custom SAW RF Filters available. Contact Oscilent for assistance. Pin Layout Test Fixture Frequency Reponse A Ground B Output C Ground D Ground E Input F Ground Oscilent Corporation RF SAW Filter | 802-RF448.0M-A Oscilent Corporation - CALL 949.252.0522 18195 East McDurmott Street . Building D . Irvine . CA 92614 . USA Fax: 949.252.0599 . E-Mail: [email protected] Page 2 of 2 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF448.0M-A