Oscilent Corporation RF SAW Filter | 802-RF881.5M-D Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 802-RF881.5M-D 3.0 x 3.0 SMD CDMA RF-Rx Jan. 01 2008 TYPE : 881.5 MHz RF SAW Filter PART NUMBER : 802-RF881.5M-D OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 881.5 - MHz 869.0 ~ 894.0 MHz - 2.2 3.0 dB DC Voltage - - - 5 V Input Power - - - 15 dBm Operating Temperature - -30 - +80 °C Storage Temperature - -40 - +85 °C 869.0 ~ 894.0 MHz - 0.6 1.5 dB dB Center Frequency Insertion Loss Ripple Stopband Attenuation VSWR Source and Load Impedance DC ~ 779MHz 50.0 60 - 779.0 ~ 849.0 MHz 42 47 - 914.0 ~ 970.0 MHz 26 30 - 970.0 ~ 1049.0 MHz 50 58 - 1049.0 ~ 2000.0 MHz 45 55 - 869.0 ~ 894.0 MHz - 1.6 2.0 - - - 50 - ohm * Maximum Rating (Ta=25°C) ** Custom SAW RF Filters available. Contact Oscilent for assistance. Pin Layout Frequency Reponse A Ground B Output C Ground D Ground E Input F Ground Oscilent Corporation RF SAW Filter | 802-RF881.5M-D Page 2 of 2 VSWR (S11, S22) Smith Chart Oscilent Corporation - CALL 949.252.0522 18195 East McDurmott Street . Building D . Irvine . CA 92614 . USA Fax: 949.252.0599 . E-Mail: [email protected] Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF881.5M-D