RF SAW Filter Part Number Package Application Last Modified 860-RF836.5M-F 1.6 x 2.0 SMD CDMA Mar.10, 2007 . TYPE : CDMA, RF-Tx SAW Filter PART NUMBER : 860-RF836.5M-F .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Condition Minimum Typical Maximum Units - - 836.5 - MHz 824.0~ 849.0 MHz - 2.1 2.9 dB DC ~ 770 MHz 30 35 - 770 ~ 804 MHz 32 36 - 869 ~ 894 MHz 40 47 - 894 ~ 1080 MHz 33 36 - 1080 ~ 1500 MHz 32 35 - 1500 ~ 2000 MHz 34 38 - dB 2000 ~ 2600 MHz 28 33 - Source Impedence (single ended)* - - 50 - Load Impendance (single ended)* - - 50 - ohm VSWR 824.0~ 849.0 MHz - 1.9 2.2 dBp-p Amplitude Ripple 824.0~ 849.0 MHz - 0.7 1.4 dBp-p Maximum DC Voltage - - - 5 V Maximum Input Power - - - 15 dBm Operating Temperature - -30 - +85 ºC ohm * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Out D Ground Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: 860-RF836.5M-F Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map