SLPOWER LS15-05

LS15
Series Line Splitter
PoE
1 Year Warranty
• Power over Ethernet (PoE)
• Converts POE to Separate Power and Data Lines
• High Efficiency: 90%, 24V unit
• Industry Leading Small Profile; 3”x 2.1”x 1”
• Meets IEEE 802.3AF
• Full Thermal Protection
• Short Circuit & Overload Protection
• Input Shutdown
• UVLO / OVLO
• Surge Protection
International Safety Standard Approvals
Specifications
General Specifications
Standard
Efficiency In Midspan configuration
5V
12V
24V
Measured from Data/Power pins of RJ45 connector, to.output of std Switchcraft 712A conn.
87% min.
88% min.
90% min.
1% of V-out, 20MHz BW
Switching Frequency
200kHz +/- 1%
Recovery time 100Usec to 1% V-out (SR= 1a/10Usec)
I-overload
120% ± 5%
Short Circuit Auto recovery when short is removed
Output Specifications
Line and Load Voltage Regulation +/-1% V-out
Transient Response
1% of V-out (50%-100% load deviation)
Overvoltage Protection Transorb protected
Output Connection
Output Noise
Input Specifications
Input
36-57 Vdc
Input Current Overload Protection
Reset power to start unit
When Iin > 450mA for 75mSec, input latches off
Input Surge
Transorb protected
Thermal Shutdown
Internally protected against over-temp conditions.
Input Undervoltage
Turn on Turn off
33-42Vdc
30-34Vdc
Approvals and Safety Standards TUV Pending
Case and Dimension 3.0L x 2.1W x 1.0H (in)
Weight
58g (2.05oz)
Input Connector Standard RJ45 connector
Environmental Specifications
Operating temperature -40°C to +60°C
Storage Temperature
-40°C to +85°C
Max ambient operating Temp
60*C @ Full load
SL Power Electronics Corp • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:805.487.8911 • Email:[email protected] • www.slpower.com
LS15
Series Line Splitter
PoE
Ault Part Number
For the most current data and application support visit www.slpower.com
Output
Voltage Output Current
Per IEEE 802.3AF*
Output
Power
Efficiency
(with cable)
LS15-05
5 V DC 2.00 A 10.0 W
480 mV
LS15-12
12 V DC
0.90 A 10.8 W
480 mV
LS15-24
24 V DC
.475 A 11.4 W
480 mV
Notes
* Power limited per Input requirements of IEEE802.3af Table 33-12. I-port Max=350mA @V-port=37V./ I-port Max=260mA @V-port=57V
Higher outputs available for non-compliant systems
Outline Configuration
2 of 3
SL Power Electronics Corp. • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:805.487.8911 • Email:[email protected] • www.slpower.com
LS15
Series Line Splitter
PoE
Data/Power in & Data Out Connection
Power Out Connection
87654321
Standard RJ45 Jack
Configuration- For 802.3af compliant units
Pin
Mode A
Mode B
1
Pos Vport, Neg Vport
2
Pos Vport, Neg Vport
3
Neg Vport, Pos Vport 4
Pos Vport, Neg Vport
5
Pos Vport, Neg Vport
6
Neg Vport, Pos Vport
7
Neg Vport, Pos Vport
8
Neg Vport, Pos Vport
Description
Switchcraft RAPC 712A connector or equivalent
Pinout Code
Center contact: positive
Suggested Mating Switchcraft 760 plug or equivalent
Description
12”, 18AWG Cable w Switchcraft S760 connector or equivalent
Pinout Code
Center contact: positive
Suggested Mating Switchcraft 722A plug or equivalent
Description
12”, 18AWG Cable w Switchcraft 760 connector or equivalent
Pinout Code
Center contact: positive
Suggested Mating Switchcraft 712A plug or equivalent
3 of 3
SL Power Electronics Corp • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:805.487.8911 • Email:[email protected] • www.slpower.com
Data Sheet © 2007 SL Power Electronics Corp. The information and specifications contained in this data sheet are believed to be correct at time of publication. However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
Rev. 04/19/07