SPECTRUM MIQ5XSMD-1

I/Q Mixer / Modulator
Model MIQ5xSMD-1
Communications Band
RF 5.6 to 9.0 GHz
Electrical Specifications: (1)
Specifications
Conditions
Parameter
SSB Conversion
loss: (2) (3)
Image Rejection Sideband Suppression: (4)
Amplitude Match
Phase Match
Isolation
LO to RF:
LO to I/Q:
RF to I/Q:
I/Q to RF:
Input 1 dB
Compression Point:
RF (GHz)
5.6-9.0
LO (GHz)
5.6-9.0
IF (MHz)
DC-500
Min
Typical
5.0 dB
5.8-8.8
5.6-9.0
5.6-9.0
5.6-9.0
5.8-8.8
5.6-9.0
5.6-9.0
5.6-9.0
DC-500
DC-500
DC-500
DC-500
22 dB
18 dB
33 dB
32 dB
0.2 dB
3 deg
25 dB
25 dB
31 dB
40 dB
26 dB
40 dB
+5 dBm
+8 dBm
+12 dBm
+14 dBm
+17 dBm
+21 dBm
+10 dBm
+13 dBm
+17 dBm
5.6-9.0
5.6-9.0
5.6-9.0
5.6-9.0
5.6-9.0
DC-500
DC-500
Input Third Order
Intercept Point:
5.6-9.0
5.6-9.0
DC-500
LO Power: (5)
5.6-9.0
5.6-9.0
DC-500
Notes:
1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25˚C with the
nominal LO power. Specifications indicated as typical are not guaranteed.
2. Noise figure is typically within ±0.5 dB of conversion loss for IF frequencies greater than 10 MHz.
3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -55˚C. Conversion
loss is the combined value.
4. Measured with an IF quadrature hybrid whose amplitude and phase errors are 0.5 dB and 3 degrees maximum.
An IF quadrature hybrid is not included.
5. Usable LO drives are up to 2 dB below to 3 dB above nominal.
6. See Application notes M112, for aid in selecting the outline and for mounting and installation information.
MIQ5xSMD-1
Model MIQ5xSMD-1
Max
6.5 dB
LO Power
4 = +10 dBm
6 = +13 dBm
7 = +17 dBm
MIQ54
MIQ56
MIQ57
MIQ54
MIQ56
MIQ57
MIQ54
MIQ56
MIQ57
Typical Performance at 25˚C
Outline: SMQD7
All dimensions are in inches and [mm].
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, FL 32905 · PH (888) 553-7531 · Fax (888) 553-7532
www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, PA 19154 · PH (215) 464-4000 · Fax (215) 464-4001
Rev.
10/8/08