8 Pin DIP Dual Fast Logic TTL Compatible Active Delay Lines DELAY TIME* 5±1 6±1 7±1 8±1 9±1 10 ± 1.5 11 ± 1.5 12 ± 1.5 13 ± 1.5 14 ± 1.5 15 16 17 PART NUMBER DELAY TIME* PART NUMBER DELAY TIME* PART NUMBER EPA509-5 EPA509-6 EPA509-7 EPA509-8 EPA509-9 EPA509-10 EPA509-11 EPA509-12 EPA509-13 EPA509-14 EPA509-15 EPA509-16 EPA509-17 18 19 20 21 22 23 24 25 30 35 40 45 50 EPA509-18 EPA509-19 EPA509-20 EPA509-21 EPA509-22 EPA509-23 EPA509-24 EPA509-25 EPA509-30 EPA509-35 EPA509-40 EPA509-45 EPA509-50 55 60 65 70 75 80 85 90 95 100 150 200 250 EPA509-55 EPA509-60 EPA509-65 EPA509-70 EPA509-75 EPA509-80 EPA509-85 EPA509-90 EPA509-95 EPA509-100 EPA509-150 EPA509-200 EPA509-250 Delay Times referenced from input to leading edges at 25°C, 5.0V, with no load. * Unless otherwise specified, delay tolerance is ± 2 nS or ± 5%, whichwver is greater. DC Electrical Characteristics Parameter Test Conditions VOH VOL VIK IIH High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current IIL IOS Low-Level Input Current Short Circuit Output Current ICCH ICCL TRO NH NL High-Level Supply Current Low-Level Supply Current Output Rise Time Fanout High-Level Output Fanout Low-Level Output V CC = min. VIL = max. I OH = max 2.7 V CC = min. VIH = min. I OL= max V CC = min. II = II K V CC = max. VIN = 2.7V V CC = max. VIN = 5.25V V CC = max. VIN = 0.5V V CC = max. VOUT = 0. -40 (One output at a time) V CC = max. VIN = OPEN V CC = max. VIN = 0 V CC = max. VOH = 2.7V V CC = max. VOL = 0.5V Recommended Operating Conditions VCC VIH VIL IIK IOH IOL PW* d* TA Schematic Min Max Unit Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 0.5 -1.2V 50 1.0 -2 -100 V V V µA mA mA mA 8 1 Max Unit 4.75 2.0 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 PCA EPA509-5 Date Code 1 .500 Max. Unit 3.2 110 2.0 1.0 5.0 .280 Max. WHITE DOT PIN#1 .020 Typ. .250 Max. Input Pulse Test Conditions @ 25° C .010 Typ. .120 Min. . .100 Typ. .365 Max. Volts % nS MHz Volts QAF-CSO1 Rev. B 8/25/94 DSA509 8/25/94 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 .XX = ± .030 .XXX = ± .010 5 4 GROUND 90 mA 90 mA 4 nS 20 TTL LOAD 10 TTL LOAD .020 Typ. Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate Supply Voltage 7 Package Dimensions Min *These two values are inter-dependent. EIN PW TRI PRR VCC VCC ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791