14 Pin DIP High Precision Single Output TTL Compatible Active Delay Lines TIME DELAYS (nS) 5±1 6±1 7±1 8±1 9±1 10±1 11±1 12±1 13±1 14±1 15±1 16±1 17±1 18±1 19±1 20±1 21±1 22±1 PART NUMBER TIME DELAYS (nS) EPA500-5 EPA500-6 EPA500-7 EPA500-8 EPA500-9 EPA500-10 EPA500-11 EPA500-12 EPA500-13 EPA500-14 EPA500-15 EPA500-16 EPA500-17 EPA500-18 EPA500-19 EPA500-20 EPA500-21 EPA500-22 PART NUMBER 23±1 24±1 25±1 30±1.5 35±1.5 40±1.5 45±2 50±2 55±2 60±2 65±2.5 70±2.5 75±2.5 80±2.5 85±3 90±3 95±3 100±3 TIME DELAYS (nS) EPA500-23 EPA500-24 EPA500-25 EPA500-30 EPA500-35 EPA500-40 EPA500-45 EPA500-50 EPA500-55 EPA500-60 EPA500-65 EPA500-70 EPA500-75 EPA500-80 EPA500-85 EPA500-90 EPA500-95 EPA500-100 PART NUMBER 125±4 150±4.5 175±5 20±6 225±7 250±8 275±9 300±10 359±11 400±12 450±14 500±15 600±18 700±20 800±22 900±24 1000±26 EPA500-125 EPA500-150 EPA500-175 EPA500-200 EPA500-225 EPA500-250 EPA500-275 EPA500-300 EPA500-350 EPA500-400 EPA500-450 EPA500-500 EPA500-600 EPA500-700 EPA500-800 EPA500-900 EPA500-1000 Delay Times referenced from input to leading edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter Test Conditions VOH VOL VIK IIH Schematic Min Max Unit High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current VCC = min. VIL = max. I OH = max 2.7 VCC = min. VIH = min. I OL= max VCC = min. II = II K VCC = max. VIN = 2.7V VCC = max. VIN = 5.25V IIL Low-Level Input Current VCC = max. VIN = 0.5V IOS Short Circuit Output Current VCC = max. VOUT = 0. -40 ICCH High-Level Supply Current VCC = max. VIN = OPEN ICCL Low-Level Supply Current VCC = max. VIN = 0 TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) NH Fanout High-Level Output VCC = max. VOH = 2.7V NL Fanout Low-Level Output VCC = max. VOL = 0.5V Recommended Operating Conditions VCC VIH VIL IIK IOH IOL PW* d* TA Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature Min Max Unit 4.75 2.0 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 Input Pulse Test Conditions @ 25° C VCC Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS Supply Voltage 14 Unit 3.2 110 2.0 1.0 100 5.0 7 GROUND Package Dimensions White Dot Pin#1 PCA EPA500-5 Date Code .280 Max. .780 Max. .020 .040 .600 Volts % nS MHz KHz Volts .010 Typ. .150 Typ. .020 Typ. .365 Max. QAF-CSO1 Rev. B 8/25/94 DSA500 8/25/94 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 .XX = ± .030 .XXX = ± .010 8 OUTPUT VCC INPUT 1 .250 Max. *These two values are inter-dependent. EIN PW TRI PRR V 0.5 V -1.2 V 50 µA 1.0 mA -2 mA -100 mA 75 mA 75 mA 4 nS 20 TTL LOAD 10 TTL LOAD ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791