SMD 14 Pin Gull-Wing Quad TTL Compatible Active Delay Modules DELAY TIME ±5% or ±2 nS† 5 6 7 8 9 10 11 12 13 14 15 †Whichever is greater. PART NUMBER DELAY TIME ±5 or ±2 nS† PART NUMBER DELAY TIME ±5% or ±2 nS† PART NUMBER EPA366-5 EPA366-6 EPA366-7 EPA366-8 EPA366-9 EPA366-10 EPA366-11 EPA366-12 EPA366-13 EPA366-14 EPA366-15 16 17 18 19 20 21 22 23 24 25 30 EPA366-16 EPA366-17 EPA366-18 EPA366-19 EPA366-20 EPA366-21 EPA366-22 EPA366-23 EPA366-24 EPA366-25 EPA366-30 35 40 45 50 55 60 65 70 75 EPA366-35 EPA366-40 EPA366-45 EPA366-50 EPA366-55 EPA366-60 EPA366-65 EPA366-70 EPA366-75 Delay times referenced from input to leading edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter Test Conditions VOH VOL VIK IIH High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current IIL IOS Low-Level Input Current Short Circuit Output Current ICCH ICCL TRO NH NL High-Level Supply Current Low-Level Supply Current Output Rise Time Fanout High-Level Output Fanout Low-Level Output VCC = min. VIL = max. I OH = max VCC = min. VIH = min. IOL= max VCC = min. II = IIK VCC = max. VIN = 2.7V VCC = max. VIN = 5.25V VCC = max. VIN = 0.5V VCC = max. VOUT = 0. (One output at a time) VCC = max. VIN = OPEN VCC = max. VIN = 0 2.7 -40 VCC = max. VOH = 2.7V VCC = max. VOL = 0.5V Recommended Operating Conditions VCC VIH VIL IIK IOH IOL PW* d* TA Schematic Min Max Unit Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 0.5 -1.2V 50 1.0 -2 -100 V V V µA mA mA mA 14 8 4 5 7 GROUND Max Unit 4.75 2.0 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 .055 .400 Max. PCA EPA366-5 Date Code .280 Max. Suggested Solder Pad Layout .410 .03 .100 .780 Max. .01 Typ. Unit 3.2 110 2.0 1.0 100 5.0 .02 .100 .050 .300 Volts % nS MHz KHz Volts QAF-CSO1 Rev. B 8/25/94 DSA366 Rev. A 2/5/96 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 16 .XX = ± .030 .XXX = ± .010 3 Package Dimensions Min Input Pulse Test Conditions @ 25° C VCC 10 9 .250 Max. Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS Supply Voltage 12 1 150 mA 150 mA 4 nS 20 TTL LOAD 10 TTL LOAD *These two values are inter-dependent. EIN PW TRI PRR VCC ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791