5.8mm Round ® Optopipe® Optical Light Pipe, Single MicroLED SMT LEDs for use with 515-1038 22.35 [.880] 11.68 [.460] 5.84 [.230] 10.92 [.430] 8.13 [.320] 515-1038 FRONT PANEL Ø 5.84 [.230] PART NO. CURVED& DIFFUSED FRONT SURFACE 5.3 [.21] 2.54 [.100] 4.39 [.173] 8.79 [.346] 1.09 [.043] TYP .41 [.016] TYP 18.54 [.730] 25.40 [1.00] NOTE: designed for post-reflow PC board insertion. DIRECTION OF LIGHT 8.79 ±.08 [.346 ±.003] 7.62 [.300] 1.50 [.059] TYP .76 [.030] [Ø .113 ±.002] TYP; 2 PLCS 3.81 [.150] Ø 2.95 [.116] MOUNTING PINS; (2) PLACES 1.50 [.059] TYP Dimensions in mm [inches] RECOMMENDED SOLDER PAD/HOLES LAYOUT Recommended 597-3xx1-2xx 597-77x1-2xx Alternatives 597-3xx1-1xx 597-3xx1-4xx 597-3xx1-5xx 597-77x1-1xx 597-77x1-5xx PAGE # 1-21 1-23 & 1-24 1-19 1-28 1-30 1-20 1-31 LED alternatives may not produce optimum light output Solder Pad/Holes layout shown is for bi-color LEDs listed under “Recommended” category Contact factory for other layouts Features • • • • • High transmissivity polycarbonate material UL94V-0 compliance ESD protection (circuit isolation from front panel) Wide viewing angle Secures to PCB by press-fit LED Data For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. Operating/Storage Temperature –30°C to +100°C Dialight Optopipe® Light Pipe Description This Optopipe® is a shorter version of 515-1039. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe® solutions for your applications. Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com