3.2mm Round ® Optopipe® Optical Light Pipe, 2 Array, Panel Mounted LEDs for use with 515-1033 19.05 [.75] REF 2.79 [.110] REF Recommended .61 [.024] .99 [.039] TYP 4.57 [.18] TYP (2) PLACES DIFFUSED FRONT SURFACES 13.97 [.550] Ø 5.08 [.200] (2) PLACES 1.78 [.07] Ø 3.20 [.126] 2 PLACES 515-1033 MAJOR DIA. Ø 3.71 [0.146] PRESS-FI T RIBS TYP, 3 PLCS DIRECTION OF LIGHT FRONT PANEL TOP SURFACE OF LED .51 [.020] MAX 4.32 [.17] Dimensions in mm [inches] Features • High transmissivity polycarbonate material • UL94V-0 compliance • ESD protection (circuit isolation from front panel) • Wide viewing angle • Arrays reduce insertion costs • Secures to panel by press-fit (Also recommend supplement means of securing -for example, clamping) 521-9247 521-9249 521-9251 550-xx10 550-5504 550-5505 550-5507 550-5508 550-5604 550-5605 550-5607 550-5608 550-5704 550-5705 550-5707 550-5708 PAGE # 6-44 6-44 6-44 6-17 6-9 6-11 6-13 6-15 6-9 6-11 6-13 6-15 6-9 6-11 6-13 6-15 Alternatives 521-9430 521-9431 521-9432 4-61 4-61 4-61 LED alternatives may not produce optimum light output LED Data Operating/Storage Temperature For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. –30°C to +100°C Dialight Optopipe® Light Pipe Description This Optopipe® is clamped to the inside of the plastic panel. The light pipe is not attached to the PCB at any point but floats in front of it. The splines on the tubular section on the right hand side hold the light pipe in place for the clamping operation. The funnel end faces the light source. The tubular sections fit through the plastic panel. The light emitting surface is textured to diffuse the light passing through it. The light source can be any super-bright 2mm, 3mm, or 5mm LED, or one of Dialight’s 597 Series SMT LEDs. The light source’s emitting surface should be located no more than 0.020" or 0.5mm from the Optopipe®. The light sources are mounted in a straight line facing the rear of the light pipe on a 14mm pitch. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe® solutions for your applications. Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com