3.0x2.0mm SURFACE MOUNT LED LAMP AA3020SYCK Features z 3.0MM X 2.0MM, 1.4MM HIGH, ONLY MINIMUM SPACE REQUIRED. z SUITABLE FOR COMPACT OPTOELECTRONIC SUPER BRIGHT YELLOW Description The Super Bright Yellow source color devices are made with DH InGaAlP on GaAs substrate Light Emitting Diode. APPLICATIONS. z LOW POWER CONSUMPTION. z PACKAGE : 2000PCS / REEL. z RoHS COMPLIANT Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAD1219 REV NO: V.3 DATE: MAR/17/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1201000150 Selection Guide Part No. Dice SUPER BRIGHT YELLOW (InGaAIP) AA3020SYCK Iv (mcd) @ 20mA Lens Type WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 36 100 90° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Yellow λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 590 nm IF=20mA Super Bright Yellow 590 nm IF=20mA Spectral Line Half-width Super Bright Yellow 20 nm IF=20mA C Capacitance Super Bright Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Yellow Units Power dissipation 125 mW DC Forward Current 30 mA Peak Forward Current [1] 175 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1219 REV NO: V.3 DATE: MAR/17/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1201000150 Super Bright Yellow AA3020SYCK SPEC NO: DSAD1219 REV NO: V.3 DATE: MAR/17/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1201000150 AA3020SYCK Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD1219 REV NO: V.3 DATE: MAR/17/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1201000150