10 Watts, 50 Ω General Specifications Resistive Element: Substrate: Cover: Mounting Flange: Lead(s): Thick film Aluminum nitride ceramic Alumina ceramic Copper, nickel plated per QQ-N-290 99.99% pure silver (.005” thk) Features • DC – 6.0 GHz Electrical Specifications • 10 Watts Resistance Value: Frequency Range: Power: V.S.W.R.: • Aluminum Nitride (AlN) ceramic • Welded Silver Leads • Non-Nicrome Resistive Element Aluminum Nitride Flanged Terminations Model RFP-10N50TV Aluminum Nitride Terminations 50 ohms, ±5% DC - 6.0 GHz 10 Watts 1.25:1 Notes: Tolerance is ±.010, unless otherwise specified. Operating temperature is -55°C to +150°C (see chart). Designed to meet or exceed applicable portions of MIL-E-5400. All dimensions are in inches. Lead length 0.15” minimum. Specifications subject to change without notice. • Low VSWR • 100% Tested Outline Drawing .200 .100 .060 .116 DIA. .100 .300 .050 N50 .100 .130 VER. 12/5/01 Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369 1 Aluminum Nitride Flanged Terminations Model RFP-10N50TV Typical Performance Suggested Mounting Procedures Power Derating % OF RATED POWER .025 MIN. (2 PLACES) 100 BOARD LOWER THAN LEAD. SUGGESTED STRESS RELIEF METHODS 75 SCALE: 50 25 0 25 50 75 100 125 CASE TEMPERATURE — °C 2 BOARD EVEN WITH LEAD. 150 BOARD LOWER THAN LEAD. BOARD HIGHER THAN LEAD. NOT RECOMMENDED APPLICATION SCALE: 1. Make sure that the devices are mounted on flat surfaces (.001" under the device) to optimize the heat transfer. 2. Drill & tap the heatsink for the appropriate thread size to be used. 3. Coat heatsink with a minimum amount of high quality silicone grease (.001" max. thickness). 4. Position device on mounting surface & secure using socket head screws, flat & split washers. Torque screws to the appropriate value. Make sure that the device is flat against the heatsink. (Care should be taken to avoid upward pressure of the leads towards the lid). 5. Solder leads in place using an SN63 type solder with a controlled temperature iron (700°F). Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369