4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 x x x x x Packaged in tubes Compatible with automatic placement equipment Compatible with infrared and vapor phase reflow solder process Mono-color type Pb-free Product Photo Here The OVFSQ4C8 is designed with higher forward voltage to maximize brightness and incorporates a low-profile lens to enhance efficient light distribution. Response time is fast and it consumes less power resulting in low current requirements from circuit power supply. Tubular arrays replace neon in outdoor and indoor signs. This square package allows high-density arrays to form light engines. Applications x Automotive: Rear Stop/Turn Signal Lamps/Truck Marker Lamps x Mood-setting Decoration and Landscape Lighting x Special Decorative Interior/Exterior Lighting x Special Effects Stage Lighting x Illumination for Signs and Channel Letters x Traffic Signals, Pedestrian and Walkway Signs Part Number Material Emitted Color Flux Typ. mlm Lens Color OVFSQ4C8 AlInGaP Red-Orange 4500 Water Clear RoHS 2,3 ANODE 1,4 CATHODE Data is subject to change without prior notice. OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 [email protected] www.optekinc.com Issue 1.0 0505 Page 1 4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 Absolute Maximum Ratings TA = 25o C unless otherwise noted Storage Temperature Range -40 ~ +100°C Operating Temperature Range -40 ~ +100°C Lead Soldering Temperature (3mm from the base of the epoxy bulb)1 260°C Reverse Voltage 5V Continuous Forward Current 2 70 mA Peak Forward Current (10% Duty Cycle, PW VHF 200 mA Power Dissipation 220 mW Notes: 1. Solder time less than 5 seconds at temperature extreme. 2. Heat sink is adequate if the device is operated at ambient temperature higher than 25°C. For long term performance the drive currents between 10mA and 50mA are recommended. Please contact an Optek sales representative for more information on recommended drive conditions. Electrical Characteristics TA = 25o C unless otherwise noted PARAMETER MIN TYP MAX UNITS CONDITIONS lumen Luminous Flux 3000 4500 ---- mlm IF = 70mA VF Forward Voltage ---- 2.6 3.2 V IF = 70mA IR Reverse Current ---- ---- 100 µA VR = 5V Dominant Wavelength 612 618 628 nm IF = 70mA 50% Power Angle ---- 40 ---- deg IF = 70mA SYMBOL D 2 ½ Standard Bins (IF = 70mA) Luminous Flux mlm) Lamps are sorted to luminous flux ( V), forward voltage (VF), and dominant wavelength ( D) bins shown. Orders for OVFSQ4C8 may be filled with any or all bins contained as below. 5000-7300 M 4000-6100 L 3500-4800 K 3000-4200 J 612 628 Dominant Wavelength (nm) Luminous flux is at J bin or above. Forward Voltage (VF) Rank V4 V5 V6 V7 V8 Voltage (V) 2.2–2.4 2.4–2.6 2.6–2.8 2.8–3.0 3.0–3.2 Important Notes: 1. All ranks will be included per delivery, rank ratio will be based on the chip distribution. 2. To designate luminous intensity ranks, please contact OPTEK. Issue 1.0 Page 2 0505 OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 [email protected] www.optekinc.com 4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 Typical Electro-Optical Characteristics Curves mA % V Forward Current vs. Forward Voltage Half Power mA Relative Luminous Flux vs. Forward Current WL = 23nm mA nm Relative Luminous Flux vs. Wavelength °C Maximum Forward DC Current vs. Ambient Temperature 50% Power Angle: 40° V A Far Field Pattern Reverse Current vs. Reverse Voltage OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 [email protected] www.optekinc.com Issue 1.0 0505 Page 3 4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 Moisture Resistant Packaging 60/Tube Issue 1.0 Page 4 0505 Aluminum Moisture-proof Bag Desiccant Bar Code Label OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 [email protected] www.optekinc.com 4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 Issue 1.0 Change Description Initial Release OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 [email protected] www.optekinc.com Approval Date R. Bailey 5/19/05 Issue 1.0 0505 Page 5