PSPSP1500 Series 1500 Watt Single Output Built-In Active PFC Function AC/DC Switching Power Supply FEATURES ● 3 Year Warranty ● Low Cost, High Reliability ● 100% Full Load Burn-In Tested ● Built-In Remote Sense Function ● Built-In Remote ON/OFF Control ● Built-In Active PFC Function, ≥ 0.95 ● AC Input Active Surge Current Limiting ● Built-In Constant Current Limiting Circuit ● Built-In Active Current Sharing and Parallel Function ● Short Circuit, Overload, Over Voltage, and Over Temperature Protected SPECIFICATIONS: PSPSP1500 Series o All specifications are based on 25 C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. INPUT SPECIFICATIONS Input Voltage Range 176 ~ 264VAC (248 ~ 370VDC) Input Frequency 47 to 63Hz AC Current (typical) 8.4A @ 230VAC Inrush Current (typical) 80A @ 230VAC Leakage Current < 3.5mA @ 240VAC Power Factor (typical) 0.96 @ 230VAC and full load Remote ON/OFF Control RC+/RC-: 0 ~ 0.8V = power on; 4 ~ 10V = power off sink current < 30mA OUTPUT SPECIFICATIONS Output Voltage See Table Output Power See Table Voltage Tolerance (See Note 3) 5V output: 6%, 12V output: 3%, 13.5V & 15V outputs: 2%, 24V - 48V outputs: 1% Voltage Adjustment Range See Table Line Regulation 5V output: 0.5%, 12V - 15V outputs: 0.3%, 24V - 48V outputs: 0.2% Load Regulation 5V output: 2.0%, 12V - 48V outputs: 0.5%, Output Current See Table Ripple & Noise (max) (See Note 2) 5V output: 100mVp-p; 12V - 27V outputs: 150mVp-p; 48V output: 200mVp-p Setup, Rise Time 1500ms, 50ms @ 230VAC and full load Hold Up Time (typical) 24ms @ 230VAC and full load Temperature Coefficient ±0.03%/°C (0 ~ 50°C) PROTECTION 115 ~ 140% rated output power Overload Protection Protection Type: Constant current limiting; recovers automatically after fault condition is removed See Table Over Voltage Protection Protection Type: Shutdown output voltage; re-power on to recover 95°C (TSW1) detect on the heatsink of PFC MOSFET 90°C (TSW2) detect the winding of output choke Over Temperature Protection Protection Type: Shutdown output voltage; recovers automatically after temperature goes down GENERAL SPECIFICATIONS Efficiency (typical) See Table Withstand Voltage 3000VAC (Input to Output), 1500VAC (Input to FG), 500VAC (Output to FG) Isolation Resistance 100MΩ/500DC (Input to Output, Input to FG, and Output to FG) ENVIRONMENTAL SPECIFICATIONS Working Temperature -10°C to +60°C (refer to output load derating curve) Storage Temperature -20°C to +85°C Working Humidity 20 ~ 90% RH non-condensing Storage Humidity 10 ~ 95% RH Vibration 10 ~ 500Hz, 2G 10min./1 cycle, 60min each along X, Y, Z axes. MTBF 43,400 hours min. @ 25°C (MIL-HDBK-217F) PHYSICAL SPECIFICATIONS Weight 6900 grams Dimensions 278(L) x 129(W) x 190.5(H) mm Warranty 3 years SAFETY & EMC Safety Standards UL60950-1, TUV EN60950-1 approved EMI Conduction & Radiation Compliance to EN55022 (CISPR22) Class B Harmonic Current Compliance to EN61000-3-2,-3 EMS Immunity Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, light industry level, criteria A Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 PSPSP1500 Series 1500 Watt Single Output Built-In Active PFC Function AC/DC Switching Power Supply OUTPUT VOLTAGE / CURRENT RATING CHART Model Number Input Voltage Output Voltage Voltage Over Voltage Adjust. Range Protection Output Current Output Power Rated Power Peak Load (4) Efficiency PSPSP1500-5 5 VDC 4.75 ~ 5.5V 5.75 ~ 6.75V 217.5A 1087.5W 1200W 77% PSPSP1500-12 12 VDC 10 ~ 13.2V 13.8 ~ 16.2V 112.5A 1350W 1500W 84% 13.5 VDC 12 ~ 15V 15.5 ~ 18.2V 100.5A 1356.75W 1500W 84% 15 VDC 13.5 ~ 18V 18 ~ 21V 90A 1350W 1500W 84% 24 VDC 20 ~ 26.4V 27.6 ~ 32.4V 56.4A 1353.6W 1500W 85% PSPSP1500-27 27VDC 24 ~ 30V 31 ~ 36.5V 50.4A 1360.8W 1500W 85% PSPSP1500-48 48 VDC 41 ~ 56V 57.6 ~ 67.2V 28.5A 1368W 1500W 86% PSPSP1500-13.5 PSPSP1500-15 PSPSP1500-24 176 ~ 264 VAC (248 ~ 370 VDC) NOTES 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load, and 25°C ambient temperature. 2. Ripple & noise are measured at 20MHz bandwidth by using a 12" twisted pair-wire terminated with a 0.1uF & 47uF parallel capacitor. 3. Tolerances include set up tolerance, line regulation, and load regulation. 4. 10% Duty cycle maximum within every 30 seconds (max.). Average output power should not exceed the rated power. 5. The power supply is considered a component, which will be installed into final equipment. The final equipment must be re-confirmed that it still meets EMC directives. BLOCK DIAGRAM DERATING CURVE OUTPUT DERATING VS INPUT VOLTAGE Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 PSPSP1500 Series 1500 Watt Single Output Built-In Active PFC Function AC/DC Switching Power Supply MECHANICAL DRAWING Unit: mm AC INPUT TERMINAL PIN NO. ASSIGNMENT Pin No. Assignment 1 AC/L 2 AC/N 3 FG DC OUTPUT TERMINAL PIN NO. ASSIGNMENT Pin No. Assignment 1, 3, 5 DC OUTPUT +V 2, 4, 6 DC OUTPUT -V CONTROL PIN NO. ASSIGNMENT: MOLEX 5559-NP USES 5558 MALE CRIMP TERMINAL Pin No. Assignment Mating Connector Terminal 1 P (Current Share) 2 -S 3 G MOLEX 5556 4 RCFemale Crimp MOLEX 5557-NR 5 NC Terminal Receptacle 6 NC 7 +S 8 RC+ Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797