SUBMINIATURE SOLID STATE LAMP AM27SGD08 SUPER BRIGHT GREEN Features Description OWIDE VIEWING ANGLE. The Super Bright Green source color devices are OSUBMINIATURE PACKAGE. made with Gallium Phosphide Green Light OYOKE LEAD. OLONG LIFE-SOLID STATE RELIABILITY. Emitting Diode. OLOW PACKAGE PROFILE. OPACKAGE : 1000PCS / REEL. ORoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1320 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 1 OF 4 ERP:1202000359 Selection Guide Part No. Dice AM27SGD08 Iv (mcd) @ 20mA Lens Type Viewing Angle Min. Typ. 2θ1/2 2.6 10 40° SUPER BRIGHT GREEN (GaP) GREEN DIFFUSED Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Green λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 565 nm IF=20mA Super Bright Green 568 nm IF=20mA Spectral Line Half-width Super Bright Green 30 nm IF=20mA C Capacitance Super Bright Green 15 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Green 2.2 2.5 V IF=20mA IR Reverse Current Super Bright Green 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Green Units Power dissipation 105 mW DC Forward Current 25 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1320 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 2 OF 4 ERP:1202000359 Super Bright Green SPEC NO: DSAD1320 APPROVED: J. Lu AM27SGD08 REV NO: V.2 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 3 OF 4 ERP:1202000359 AM27SGD08 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1320 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 4 OF 4 ERP:1202000359