SUBMINIATURE SOLID STATE LAMP AM2520MGC08 Features MEGA GREEN Description SUBMINIATURE PACKAGE. The Mega Green source color devices are made with WIDE VIEWING ANGLE. DH InGaAlP on GaAs substrate Light Emitting Diode. YOKE LEAD. LONG LIFE - SOLID STATE RELIABILITY. LOW PACKAGE PROFILE. PACKAGE : 1000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1276 REV NO: V.2 DATE: MAR/05/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1202000541 Selection Guide Part No. Dice MEGA GREEN (InGaAlP) AM2520MGC08 Iv (mcd) @ 20mA Lens Type WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 280 600 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Mega Green λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 574 nm IF=20mA Mega Green 568 nm IF=20mA Spectral Line Half-width Mega Green 26 nm IF=20mA C Capacitance Mega Green 20 pF VF=0V;f=1MHz VF Forward Voltage Mega Green 2.1 2.5 V IF=20mA IR Reverse Current Mega Green 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Mega Green Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1276 REV NO: V.2 DATE: MAR/05/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1202000541 Mega Green AM2520MGC08 SPEC NO: DSAD1276 REV NO: V.2 DATE: MAR/05/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1202000541 AM2520MGC08 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength),the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1276 REV NO: V.2 DATE: MAR/05/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1202000541