SUBMINIATURE SOLID STATE LAMP AM2520SGD09 Features SUPER BRIGHT GREEN Description SUBMINIATURE PACKAGE. The Super Bright Green source color devices are made WIDE VIEWING ANGLE. with Gallium Phosphide Green Light Emitting Diode. Z-BEND LEAD. LONG LIFE - SOLID STATE RELIABILITY. LOW PACKAGE PROFILE. PACKAGE : 1000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAB7508 REV NO: V.5 DATE: MAR/07/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1202000647 Selection Guide Part No. Dice AM2520SGD09 Iv (mcd) @ 20mA Lens Type SUPER BRIGHT GREEN (GaP) GREEN DIFFUSED Viewing Angle Min. Typ. 2θ θ1/2 2.6 10 40° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Green λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 565 nm IF=20mA Super Bright Green 568 nm IF=20mA Spectral Line Half-width Super Bright Green 30 nm IF=20mA C Capacitance Super Bright Green 15 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Green 2.2 2.5 V IF=20mA IR Reverse Current Super Bright Green 10 uA VR= 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Green Units Power dissipation 105 mW DC Forward Current 25 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAB7508 REV NO: V.5 DATE: MAR/07/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1202000647 Super Bright Green AM2520SGD09 SPEC NO: DSAB7508 REV NO: V.5 DATE: MAR/07/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1202000647 AM2520SGD09 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAB7508 REV NO: V.5 DATE: MAR/07/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1202000647