MA-COM 1EGG1-2

CORCOM Product Guide
Smallest Filtered Power Entry Modules with Metric Fuseholders
GG/HG Series
UL Recognized
CSA Certified
VDE Approved
HG1/GG1
GG8
GG Series
Specifications
The GG series power entry modules combine the functions
of a general purpose RFI filter with an IEC power cord
connector and single or dual metric fusing, in the smallest
possible panel space. A choice of .250” terminals or wire
leads is available for the load-side terminations.
Maximum leakage current,each line-to-ground
HG Models
@ 120 VAC 60 Hz:
2µA
@ 250 VAC 50 Hz:
5µA
Hipot rating (one minute):
line-to-ground
line-to-line
Operating frequency:
For maximum cost effectiveness, 6 amp models should be
used for all applications rated 6 amps or less, unless the
higher performance of the 3 amp models, or the much
higher performance of the 1 amp models, is needed.
Models with C-suffix additionally incorporate a ground
choke1 to isolate the equipment chassis from external
ground at RF frequencies.
250 VAC
Fuse (not included):
Accepts one 5x20mm fuse
(-1 models) or two 5 x 20 mm
fuses (-2 models)
A medical version of our GG series, these filters offer the
same compact design but reduce the line-to-ground
capacitance in order to meet UL 2601 patient care
requirements. For more information on UL2601
specification, see Appendix C.
Minimum insertion loss in dB:
Line-to-ground in 50 ohm circuit
Note: When using the models with an IEC connector,
remember that the leakage current of the companion line
cord, GA400, is more significant than that of the filter which may disqualify this line cord from use in patient care
applications.
GG/GS Models
1A
12
3A
–
–
6A
HG Models
1A
12
3A
–
6A
–
GG/GS/HG
Current
Rating .01
.05
Frequency-MHz
.10 .15 .5
1
5
10
30
23
10
1
29
15
4
32
19
10
41
30
16
47
36
22
50
48
36
50
50
40
55
53
50
23
10
4
29
15
10
32
19
14
40
25
18
40
26
18
28
22
14
22
21
14
18
21
14
Frequency-MHz
.5
1
3
5
10
30
Note 1
LINE
LOAD
Line-to-line in 50 ohm circuit
Current
Rating
Note 2
GG-C
1550 VAC
1450 VDC
50/60 Hz
Rated voltage (max.):
HG Series
Electrical Schematics
GG Models
.25 mA
.42 mA
Note 1
LINE
LOAD
Note 2
Resistor location for reference only.
Note 1: Depicts single fuse for -1 models.
Note 2: For HG delete line-to-ground capacitors.
CAUTION: DO NOT ATTEMPT TO OPERATE A SINGLE-FUSED MODEL WITHOUT THE
FUSE DOOR IN PLACE!
GG/GS Models
1A
3A
6A
HG Models
1A
3A
6A
.01
.15
1
1
1
3
2
2
14
11
10
23
14
13
41
25
23
47
38
33
50
44
39
44
40
42
1
1
1
3
2
2
26
30
30
35
30
30
35
30
30
35
30
30
27
30
30
20
30
30
112
Catalog 1654001
Revised 05-07
Dimensions are in inches and
millimeters unless otherwise
specified. Values in italics
are metric equivalents.
Dimensions are shown for
reference purposes only.
Specifications subject
to change.
USA Cust. Svc.: 1-800-468-2023
CORCOM Prods: 1-847-680-7400
Germany:
49-89-6089-0
www.corcom.com
www.tycoelectronics.com
CORCOM Product Guide
Smallest Filtered Power Entry Modules with Metric Fuseholders (Continued)
GG/HG Series
Case Styles
EGS
GG1/HG1
C
D
C
E
D
E
B
A
B
A
Power Entry Modules
Recommended Panel Cutouts
GG / HG
Front or Back Mount
GS / HGS
Front Mount Only
1.24
31.5
1.14
29.0
Typical dimensions:
Holes: .07 [1.8] Dia.
Terminals: .250 [6.35] (3)
Mounting Holes: .126 [3.20] Dia. (2)
1.29
32.8
1.30
33.0
for panel thickness
.032-.080
[.81-2.03]
Radius: 0.138
[0.35]
GG8
1.417
36.0
Blue
Green/Yellow
Case Dimensions
Brown
B
C
D
E
A
.6
15.2
Typical dimensions:
Wire leads: 5.0 [127.0] Min. 18 AWG Mounting Holes: .126 [3.20] Dia. (2)
A
Part No.
(max)
EGG1-1/EGG1-2/
2.15
EHG1-2
54.5
EGG8-1/EGG8-2
2.02
EGG8C-1/EGG8C-2
51.1
EGS1-1/EGS1-2
2.13
EHGS1-2
54.0
EGG1C-1-1/EGG1C-2 2.45
62.23
*max
Part Number1
RFI Filter Type2
Current Rating3
Metric Fuseholders
1EGG1-1
General Purpose2
1
1
1EGG1-2
General Purpose
1
2
1EGG8-1
General Purpose
1
1
1EGG8-2
General Purpose
1
2
1
1
1EGS1-1
General Purpose
2
General Purpose
1
1EGS1-2
3EGG1-1
General Purpose
3
1
3EGG1-2
General Purpose
3
2
3
1
General Purpose
3EGG8-1
3EGG8-2
General Purpose
3
2
3EGS1-1
General Purpose
3
1
3EGS1-2
General Purpose
3
2
General Purpose
6
1
6EGG1-1
2
6
General Purpose
6EGG1-2
1
6
General Purpose
6EGG8-1
6EGG8-2
General Purpose
6
2
6EGS1-1
General Purpose
6
1
6
2
General Purpose
6EGS1-2
1EHG1-2
Medical
1
2
3EHG1-2
Medical
3
2
6EHG1-2
Medical
6
2
1EHGS1-2
Medical
1
2
2
3
Medical
3EHGS1-2
2
6
Medical
6EHGS1-2
1 Ground choke available on general purpose models. Add suffix "C" (1EGG1C-1). Does not include EGS models.
2 General purpose filter for susceptibility applications. 3 Current rating @120 VAC and 250 VAC.
B
(max)
1.13
28.7
1.13
28.7
1.13
28.7
1.13
28.7
C
(max)
1.29
32.8
1.29
32.8
1.28
32.5
1.28
32.5
D
± .015
± .38
1.417
36.0
1.417
36.0
1.46*
36.0
1.46*
36.0
E
(max)
1.76
44.7
1.76
44.7
1.42
36.1
1.42
36.1
Load Side Terminations
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
5.0 [127.0] Wire Leads
5.0 [127.0] Wire Leads
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
5.0 [127.0] Wire Leads
5.0 [127.0] Wire Leads
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
5.0 [127.0] Wire Leads
5.0 [127.0] Wire Leads
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
.250 [6.35] Terminals (3)
113
Catalog 1654001
Revised 05-07
Dimensions are in inches and
millimeters unless otherwise
specified. Values in italics
are metric equivalents.
Dimensions are shown for
reference purposes only.
Specifications subject
to change.
USA Cust. Svc.: 1-800-468-2023
CORCOM Prods: 1-847-680-7400
Germany:
49-89-6089-0
www.corcom.com
www.tycoelectronics.com