T-1, (3-mm) Round, Quad-level PCB Mount LED Indicator, J94B Series The J94B is a right-angle view assembly of 4 T-1 LEDs arranged in a column and can be CMOS driven to save components. This indicator array is designed to be the extension of the J78B and J83B. When used in conjunction with the J78B and/or J83B the lower LEDs line up both vertically and horizontally with the lamps in the latter. Recommended pitch is 4.4 mm(0.173") when a large number of units are placed side-by-side. This would allow intermixing 4-high, 3-high and 2-high indicators on the same panel. 3.5 4.3(0.17") 9.9 (0.39") 3 5.08(0.2") 5.08(0.2") 20.1 (0.79") 5.08(0.2") 2.54(0.1") 2.8 (.11) + – (Pinout for single color) Green Anode 1.9 (.075) Red or yellow Anode (typ for bi-color) Specify part desired as follows: J94B/Order Code LED1 + Order Code LED 2 + Order Code LED 3 + Order Code LED 4 For example: “J94B/I+Y+2G” designates an assembly with a red LED on top, a yellow LED in the middle and 2 green LED's on the bottom. Note: Special lead length lamps are needed for position 1. Limited choices only. ORDER CODE AND INFORMATION (ALL RATINGS AT 25°C AMBIENT) LED Lamp Epoxy & Type TInted Diffused Typical Characteristics Peak Vf (V) Iv (mcd) 2Θ1/2 λ (nm) @If=20mA @If=2 mA (Deg) Recom. Op. If (mA) 1.8 4.0 50 2 - 10 Color Order Code Red I 639 Green G 575 1.7 2.5 60 2 - 10 Yellow Y 591 1.85 4.0 45 2 - 10 * Specifications subject to change without notice. Dimensions are in mm±0.25 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph:714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 Catalog 995A