Oscilent Corporation IF SAW Filter | 813-SL140.0M-15 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL140.0M-15 13.3 x 6.5 SMD Base Station & Repeater Apr 18, 2007 . TYPE : 140.0 MHz Bandpass Filter Low Loss PART NUMBER : 813-SL140.0M-15 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 139.8 140.0 140.2 MHz Insertion Loss at Fo - 8.0 11.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth at -1.0 dB 13.6 13.8 - MHz Bandwidth at -3.0 dB 14.8 15.05 - MHz Bandwidth at -40.0 dB - 18.35 18.6 MHz Bandwidth at -45.0 dB - 18.6 19.0 MHz - dB Center Frequency - Relative Attenuation: Lower Sidelobe 45 Upper Sidelobe 48 40 45 - dB Amplitude Ripple - 0.62 1.0 dBp-p Group Delay Variation - 110 180 nsec Absolute Delay at Fo - 0.98 - µsec Temperature Coefficient - - -94 ppm/°C *With Matching Network (Reference Testing Environment Circuit as shown) Modifiy Impedance Values as necessary. . PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 813-SL140.0M-15 Page 2 of 2 PIN Description IN-11,OUT-5,GROUND-1,2,3,4,6,7,8,9,10,12 FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL140.0M-15