Oscilent Corporation IF SAW Filter | 807-IF350.0M-B Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 807-IF350.0M-B 7.0 x 5.0 SMD Mobile Communication Jan. 01, 2007 TYPE : 300.00 MHz IF SAW Filter PART NUMBER : 807-IF350.0M-B OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units MHz 349.0 350.0 350.1 Insertion Loss at Fo - 15.0 16.5 dB Bandwidth at -0.5 dB 2.4 3.1 - MHz Bandwidth at -3.0 dB - 4.8 - MHz Bandwidth at -35.0 dB - 9.4 12.0 MHz Lower Sidelobe 38 43 - dB Upper Sidelobe 38 43 - dB Temperature Coefficient - 0.03 - ppm/°C Source Impedance (Single Ended)* - 50 - ohm Load Impedance (Single Ended)* - 50 - ohm Amplitude Ripple - 0.5 1.0 dBp-p Group Delay Variation - 25 40 ns Ambient Temperature - 25 - °C Absolute Delay at Fo - 0.45 - µsec Center Frequency - Relative Attenuation: * With Matching Network (Ref. Testing Environment Circuit as shown) Modification to Impedance Values are possible if needed. PACKAGE OUTLINE (mm) TEST CIRCUIT Oscilent Corporation IF SAW Filter | 807-IF350.0M-B Page 2 of 2 TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: L1: 51.7 nH; C1: 18pF OUTPUT: L2: 48.5 nH; C2: 22pF FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 807-IF350.0M-B