Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025 800-227-4856 FAX 800-227-4866 PRODUCT: miniSMDC200 RAYCHEM DOCUMENT: SCD24406 PCN: 472815 REV LETTER: C REV DATE: OCTOBER 25, 2000 PAGE NO.: 1 OF 1 PolySwitch® PTC Devices Overcurrent Protection Device Specification Status: Released Maximum Electrical Rating D Voltage: 6VDC Short Circuit Current: 100A E C Notes: 1. All terminations are tin/lead plated. 2. Devices can be wave soldered. 3. Drawing not to scale Marking D E Marking: TABLE I. DIMENSIONS: mm: in: A B C D E MIN MAX MIN MAX MIN MAX MIN MIN MAX 4.37 4.73 3.07 3.41 0.51 1.22 0.30 0.25 -(0.172) (0.186) (0.121) (0.134) (0.020) (0.048) (0.012) (0.010) -- TABLE II. PERFORMANCE RATINGS: IHOLD ** CURRENT TRIP LIMITS** RATED CURRENT AMPERES AMPERES AMPERES AMPERES AT 20°C AT -40°C AT 20°C AT 60°C HOLD HOLD TRIP HOLD TRIP HOLD TRIP 2.00 2.60 6.00 2.00 4.00 1.50 3.00 TIME TO TRIP ** SECONDS AT 20°C, 8A MAX 5 TRIPPEDRESISTANCE VALUES STATE POWER DISSIPATION** OHMS WATTS AT AT 20°C 20°C, 6V MIN MAX* MAX 0.020 0.070 1.0 * Maximum resistance is measured 1 hour after reflow **Values Specified were determined using PCB’s with 0.030”X1.5 ounce copper traces. Reference Documents: Precedence: Effectivity: CAUTION: PS300, E. N. SMD1.0x. This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame.