RLT66100MG TECHNICAL DATA High Power Red Laser Diode Features • • • • Lasing Mode Structure: multi mode Peak Wavelength : typ. 660 nm Optical Ouput Power: 100 mW Package: 5.6 mm Electrical Connection Pin Configuration Bottom View n-type PIN 1 2 3 Function LD Cathode LD Anode, PD Cathode PD Anode Absolute Maximum Ratings (TC=25°C) Item Reverse Voltage Operating Case Temperature Storage Temperature Symbol VR TC Tstg Value 2.5 -10 … +70 -40 … +80 Unit V °C °C Specifications (TC=25°C) Item Optical Specification CW Output Power Peak Wavelength Spectral Width (FWHM) FWHM Beam Divergence Electrical Specification Threshold Current Operating Current Slope Efficiency Operating Voltage Monitor Current Symbol Min. Typ. Max. Unit PO λP Δλ θ║ θ┴ 655 6 15 100 660 3 - 665 8 25 mW nm nm deg deg Ith Iop η Uop Im 0.2 55 150 0.8 2.5 - 1.5 mA mA W/A V mA The above specifications are for reference purpose only and subjected to change without prior notice. 13.03.2012 RLT66100MG 1 of 3 Package Dimensons 5.6 mm Package (Unit:mm) 13.03.2012 RLT66100MG 2 of 3 Safety of Laser light • Laser Light can damage the human eyes and skin. Do not expose the eye or skin directly to any laser light and/or through optical lens. When handling the LDs, wear appropriate safety glasses to prevent laser light, even any reflections from entering to the eye. Focused laser beam through optical instruments will increase the chance of eye hazard. Cautions 1. Operating methode • This LD shall change its forward voltage requirement and optical ouput power according to temperature change. Also, the LD will require more operation current to maintain same ouput power as it degrades. • Confirm that electrical spike current generated by switching on and off does not exceed the maximum operating current level specified herein above as absolute maximum rating. Also, employ appropriat countermeasures to reduce chattering and/or overshooting in the circuit. 2. Static Electricity • Static electricity or electrical surges will reduce and degrade the reliability of the LDs. It is recommended to use a wrist trap or anti-electrostatic glove when handeling the product. 3. Absolute Maximum Rating • Active layer of LDs shall have high current density and generate high electric field during its operation. In order to prevent excessive damage, the LD must be operated striclty below absolute maximum rating. 13.03.2012 RLT66100MG 3 of 3