Tyco / Electronics PolySwitch® PTC Devices Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 PRODUCT: VTP170XSDF DOCUMENT: SCD 26179 PCN: A45828 REV LETTER: B REV DATE: JUNE 16, 2005 PAGE NO.: 1 OF 1 Overcurrent Protection Device Specification Status: Released Maximum Electrical Rating Operating Voltage: 16Vdc Interrupt Current: 100A Chip Size: 5 X 7mm Leads: Nickel 1/4H 0.125mm nominal thickness Solder: Lead-free Tape: Polyester (White) 8 mm nominal width Marking:(Color: Green) Manufacturer's Mark V17 Part Identification Lot Identification TABLE I. DIMENSIONS: mm: in*: A B MIN MAX MIN MAX 17.9 19.9 4.9 5.3 (0.70) (0.78) (0.19) (0.20) *Rounded off approximation C MIN --- D MAX 0.8 (0.03) MIN 6.0 (0.23) E MAX 8.6 (0.33) MIN 3.0 (0.11) F MAX 5.6 (0.22) MIN 3.9 (0.15) G MAX 4.1 (0.16) MIN MAX TABLE II. PERFORMANCE RATINGS: As measured in Mueller Kelvin Clips model BU-75K. I HOLD AMPS 25°C HOLD 1.7 CURRENT TRIP LIMITS TIME TO TRIP REFERENCE RESISTANCE AMPS AMPS AMPS AMPS SECONDS AT OHMS AT 0°C AT 25°C AT 60°C AT --°C 25°C, 8.5A AT 25°C HOLD TRIP HOLD TRIP HOLD TRIP HOLD TRIP MIN MAX MIN MAX 2.2 4.5 1.7 3.4 0.8 1.8 ------5 0.030 0.052 Recognitions: Reference Documents: Precedence: Effectivity: CAUTION: Materials Information: ROHS Compliant ONE-HOUR POST-TRIP RESISTANCE OHMS AT 25°C MIN MAX 0.030 0.105 TRIPPEDSTATE POWER DISSIPATION WATTS AT 25°C, 16V MAX 1.4 UL, TUV, CSA PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. ELV Compliant © 2005 Tyco Electronics Corporation. All rights reserved Pb-Free