Tyco / Electronics PolySwitch® PTC Devices Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 PRODUCT: RGE1100 DOCUMENT: SCD 23380 PCN: 699567 REV LETTER: P REV DATE: JUNE 29, 2005 PAGE NO.: 1 OF 1 Overcurrent Protection Device Specification Status: Released Electrical Rating Voltage: 16V MAX Current: 100A MAX Insulating Material: Cured, Flame Retardant Epoxy Polymer meets UL94 V-0 Requirements Lead Material: 20 AWG Tin/Lead Plated Copper (0.81mm [0.032] nom. diameter) Marking: Raychem Logo and Voltage 16 G1100 Part Identification Lot Identification (can be on back) TABLE I. DIMENSIONS: A mm: in*: B MIN MAX MIN MAX 16.5 17.5 21.1 26.0 (0.65) (0.69) (0.83) (1.02) *Rounded off approximation C MIN 4.3 (0.17) D MAX 5.8 (0.23) MIN 7.6 (0.30) E MAX --- MIN 2.0 (0.08) MAX 3.0 (0.12) F TYP 1.2 (0.05) TABLE II. PERFORMANCE RATINGS: I HOLD RATED CURRENT CURRENT RATINGS INITIAL RESISTANCE VALUES TIME TO TRIP AMPS AT 25°C HOLD 11.0 AMPS AT 25°C HOLD TRIP 11.0 18.7 OHMS AT 25°C MIN MAX 0.0037 0.0060 SECONDS AT 25°C, 55.0 A MAX 7.0 Agency Recognitions: Reference Documents: Precedence: Effectivity: CAUTION: R1 MAX 1 HR. POST TRIP RESISTANCE STANDARD TRIP OHMS AT 25°C MAX 0.0089 TRIPPEDSTATE POWER DISSIPATION WATTS AT 25°C TYP 3.7 UL, CSA, TUV. PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. © 2005 Tyco Electronics Corporation. All rights reserved.