TDK PFE300S-48

PFE300-1000 Series
300 to 1008W AC-DC Power Module
Features
u Low profile, small size
u 100°C baseplate temperature
u High power density
u High Efficiency
u Suitable for conduction cooling
u Power Factor Corrected (PFC)
Key Market Segments & Applications
Specifications
Model
AC Input
VAC
Input Current (100 / 220VAC)
A
Model dependant
Inrush Current (100 /200VAC) (1) A
Power Factor
Output Voltage Setpoint Accuracy Ripple and Noise
(1)
Over Current Protection
%
Over Voltage Protection
Series Operation
Parallel Operation
Power On Signal (ENA)
Auxiliary Supply
Remote On/Off (Opto isolated)
Overtemperature Protection
Operating Baseplate Temp.
°C
Storage Temperature
°C
Humidity (non condensing)
Cooling
Withstand Voltage (1 min)
(3)
Isolation Resistance
Vibration (non operating)
Shock
Safety Certifications
Weight
g
Size (WxHxL)
mm
in
Warranty
yrs
PFE300S
PFE500S
PFE700S
85 to 265VAC, 47-63Hz (up to 440Hz) (4)
8.8 / 4.4
6.8 / 3.4
4.0 / 2.0
6.2 / 3.2
±2%
1%
PFE500F
20 / 40 peak
0.95 minimum, meets EN61000-3-2
±1V
±2%
4V
1%
105 - 140% (Automatic Recovery)
125 - 145%
60 - 69.6V
125 - 145%
PFE1000F
13.6 / 6.6
±2%
1%
105 - 140%
Manual reset
125 - 145%
Yes
No
Yes (Droop mode)
Yes (Single wire)
Yes (Single wire)
Open collector (10mA sink current). Low (on) when output is present
None
None
10 - 14V, 20mA
10 - 14V, 20mA
None
None
High = On
High = On
Yes
-40 to +100°C (2)
-40 to +100°C
Operating: 20 - 95%RH, Non Operating: 10 - 95%RH
Conduction
Input to Output 3kVAC, Input to Baseplate 2.5kVAC, Output to Baseplate 1.5kVDC
Output to baseplate: 100M Ohm at 500VDC, 25°C ambient, 70%RH
10-55Hz (1 min sweep), constant amplitude 0.825mm (max 49m/s2), X, Y, Z 1 hour each
196.1m/s2
UL60950-1, CSA60950-1 (cUL), EN60950-1, CE mark (LVD)
250
250
300
500
61 x 12.7 x 116.8mm
70 x 12.7 x 122mm 100 x 13.4 x 160mm
2.4 x 0.5 x 4.6”
2.76 x 0.5 x 4.8”
3.94 x 0.53 x 6.3”
2 years
Notes: (Consult Installation Manual for detailed specifications, test methods and application notes)
1)
External components are required, consult Application Notes
2)
PFE500S-12, PFE500F-12: -40 to 85°C. See instruction manuals for derating curves
PFE1000F28 & PFE1000F48: -40 to 85°C below 170VAC input voltage.
See instruction manuals for derating curves
3)
PFE500F, PFE1000F: 500VDC Output to baseplate
4)
Reduced PFC above 63Hz. Contact technical support for 440Hz operation.
1-800-526-2324 • www.us.tdk-lambda.com/lp/
118
Disclaimer: us.tdk-lambda.com/lp/legal.htm
PFE300-1000 Series
Specifications
Model
PFE300S-12
PFE500S-12
PFE500F-12
PFE1000F-12
PFE300S-28
PFE500S-28
PFE500F-28
PFE1000F-28
PFE300S-48
PFE500S-48
PFE500F-48
PFE1000F-48
PFE700S-48
Output
Voltage (V)
12
12
12
12
28
28
28
28
48
48
48
48
51
Adjust.
Range (V)
9.6 - 14.4
9.6 - 14.4
9.6 - 14.4
9.6 - 14.4
22.4 - 33.6
22.4 - 33.6
22.4 - 33.6
22.4 - 33.6
38.4 - 57.6
38.4 - 57.6
38.4 - 57.6
38.4 - 57.6
None
Maximum
Current (A)
25
33
42
60
10.8
18
18
36
6.3
10.5
10.5
21
14
Maximum
Wattage (W)
300
396
504
720
302
504
504
1008
302
504
504
1008
714
Load
Line
Reg. (mV)
Reg. (mV)
48
48
48
48
48
48
48
48
56
56
56
56
56
56
56
56
96
96
96
96
96
96
96
96
50 - 57V (5)
Efficiency
typ (4)
81 / 83
82 / 83
81 / 83
80 / 82
83 / 85
84 / 86
84 / 86
84 / 86
84 / 86
84 / 86
84 / 86
84 / 86
86 / 89
(4) 100 / 200VAC
(5) Total regulation range
PFE500S & PFE700S Outline Drawing
PFE500F Outline Drawing
5.0±0.5
12.7
CL
See note A
See note D
AC (N)
AC(L)
AC (L)
PFE500F-48
-V
+V
+BC
12.0
+S
TRIM
+ON/OFF
IOG
-ON/OFF
ENA
AUX
COM
-S
PC
+ON/OFF
-ON/OFF
AUX
+S
TRIM
IOG
ENA
COM
-BC
MADE IN JAPAN
R
+BC
2.54
-BC
2.54
9.93
29.73
BAR CODE
R
-S
PC
2.54
EN6 0 9 5 0
2.54
AC-DC
2.54
59.7±0.5
70.0±0.5
12.0
5.78
CL
-V
+V
INPUT:100-240VAC 8A
50/60Hz
OUTPUT:48V
10.5A
5.78
AC(N)
See note C
3.7
See note E
5.26
15.0
See note B
15.0
54.12
111.8±0.5
122.0±0.5
Lot No. seal
PFE500S Basic connection
Heatsink Table (PFE-S Models only)
Heatsink
HAF-10L
HAF-15L
HAF-15T
HAL-F12T
HAM-F10T
Size (mm)
116.8 x 25.4 x 61
116.8 x 38.1 x 61
116.8 x 38.1 x 61
122 x 35 x 69.9
160 x 33.4 x 100
PFE Module
PFE300/500S
PFE300/500S
PFE300/500S
PFE500F
PFE1000F
Options
Suffix
Blank
/T
Description
M3 tapped mounting inserts (4)
3.3mm non-threaded inserts (4)
For Additional Information, please visit
us.tdk-lambda.com/lp/products/pfe-series.htm
1-800-526-2324 • www.us.tdk-lambda.com/lp/
119
Revision C4: Mar 2013