Series AMLD-IZ Up to 2000mA | LED Driver FEATURES: • • • • High Power LED Driver Wide (7:1) Input Voltage Range Remote Control Function 24 Pin DIP Package • • • Constant Output Current High Efficiency (Up to 96%) Dimming Function (0 – 100%) Models Single output Model Input Voltage (V) Output Voltage (V) Output Current (mA) Efficiency Max (%) 5-36 5-36 5-36 5-36 5-36 5-36 5-36 5-36 5-36 5-36 5-36 5-36 5-36 5-36 5-36 5-36 2-32 2-32 2-32 2-32 2-32 2-32 2-32 2-32 2-32 2-32 2-32 2-32 2-32 2-32 2-32 2-32 300 350 500 600 700 800 900 1000 1100 1200 1300 1400 1500 1600 1800 2000 96 96 96 96 96 96 96 96 96 96 95 95 95 95 95 95 AMLD-3630IZ AMLD-3635IZ AMLD-3650IZ AMLD-3660IZ AMLD-3670IZ AMLD-3680IZ AMLD-3690IZ AMLD-36100IZ AMLD-36110IZ AMLD-36120IZ AMLD-36130IZ AMLD-36140IZ AMLD-36150IZ AMLD-36160IZ AMLD-36180IZ AMLD-36200IZ NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. Input Specifications Parameters Nominal Typical Maximum Units Voltage range 24 5-36 36 VDC On/Off Control (Analog Control) ON: Open or 0V> V <0.6V Input voltage range (0-12Vdc) OFF: 0.6V> V <5V (1mA Max) (Leave open if not used) Dimming Control (Digital Control) Max PWM Frequency (10%~90%) 200Hz / 20KHz for 1.6A, 1.8A, 2.0A models 0-4.5V (1mA max) Analog Voltage (0%~100%) models: AMLD-3630IZ, AMLD-3635IZ, Dimming Control (Analog Control) AMLD-3650IZ Input voltage range (0-12Vdc)* (Leave open if not used) 0-6.5V (1mA max) Analog Voltage (0%~100%) models: AMLD-3660IZ, AMLD-3670IZ, For models with 1.5A and below AMLD-3680IZ, AMLD-3690IZ, AMLD-36100IZ, AMLD-36110IZ, AMLD-36120IZ * NOTE: Exceeding 12Vdc on Dimming Control pin will damage the converter. Output Specifications Parameters Current accuracy Short Circuit protection Output Open Protection Max load capacitance Ripple & Noise Conditions 20MHz Bandwidth Typical Maximum Units ±2 Regulated at the rated current for each model No Load 100 300 % µF mV p-p General Specifications Parameters Switching frequency Operating temperature Storage temperature www.aimtec.com F 051e R12.K Conditions Typical 100% load 260 Maximum Units 1.5MHz for 1.6A, 1.8A, 2.0A models -40 to +85 -40 TO +70 (1.2A, 1.3A, & 1.5A, 1.6A, 1.8A, 2.0A models) -40 to +125 Tel: +1 514 620 2722 1 of 13 KHz o C o C Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver General Specifications (continued) Parameters Conditions Max Case temperature Cooling Thermal Impedance Humidity Case material Potting material Weight Typical Maximum Units 100 C o Free Air Convection o C/W % RH 95 Non-Conductive Black Plastic, Nickel-Coated Copper 1.3A, 1.4A & 1.5A models) Epoxy (Flammability UL94V-0) 12 g 1.25 × 0.80 × 0.40 inches / 31.80 × 20.30 × 10.20 mm 1.25 × 0.80 × 0.45 inches / 31.80 × 20.30 × 11.30 mm (1.3A, 1.4A, & 1.5A models) 1.99 x 0.99 x 0.37 inches / 50.70 x 25.30 x 9.55 mm (1.6A, 1.8A, 2.0A models) 13.17 Dimensions (L x W x H) Safety Specifications Parameters Agency approvals Standards CE EN 55022, class B EN55024: IEC 61000-4-2 (Perf. Criteria B) Pin Out Specifications IEC 61000-4-3 (Perf. Criteria A) IEC 61000-4-6 (Perf. Criteria A) IEC 61000-4-8 (Perf. Criteria A) Dimensions Single 1 Remote On/Off 2 -Vin 3 -Vin 9 NC 11 NC 14 LED + 16 LED 22 +Vin 23 +Vin 24 DIM NC: Not Connected Pin Mechanical Tolerances Case tolerance ± 0.25mm or ± 0.01 inches Pin tolerance ± 0.05 or ± 0.002 www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 2 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver Dimensions (1.3A, 1.4A, & 1.5A models) 20.32 (0.80) 5.60 (0.22) 9.55 (0.375) 2.49 (0.098) 7.62 (0.30) 25.30 (0.99) 10.11 (0.40) 25.30 (0.99) Dimensions (1.6A, 1.8A, & 2.0A models) Pin 1 2 3 4 5 Single +Vin -Vin Remote On/Off & PWM Dimming LED + LED - www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 3 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver Efficiency versus Input Voltage Efficiency (%) 100 80 60 40 20 0 0 5 10 15 20 25 30 Input Voltage (V) Derating www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 4 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver Application Circuit Note: The relation between input and output voltage for AMLD-IZ LED Driver step-down converter series is: Vin – 4V ≧ Vout ≧ Total LED voltage Vout / LED voltage = LED quantity Output Current versus Dimming Voltage Output Current vs VADJ AMLD-3630IZ ILED (mA) 350 300 301 250 221 200 150 147 100 76 50 2 0 0V 1V 2V 3V 4V 0 5V VADJ (V) www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 5 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver Output Current versus Dimming Voltage (continued) Output Current vs VADJ AMLD-3635IZ ILED (mA) 400 365 350 300 284 250 210 200 150 138 100 61 50 0 0V 1V 2V 3V 0 5V 4V VADJ (V) Output Current vs VADJ AMLD-3650IZ ILED (mA) 600 500 520 407 400 300 287 200 181 100 68 0 0V 1V 2V 3V 4V 0 5V VADJ (V) www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 6 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver Output Current versus Dimming Voltage (continued) Output Current vs VADJ AMLD-3660IZ ILED (mA) 700 629 600 500 485 400 348 300 220 200 100 87 0 0V 1V 2V 3V 0 5V 4V VADJ (V) Output Current vs VADJ AMLD-3670IZ ILED (mA) 800 700 711 600 570 500 432 400 300 297 200 163 100 23 0 0V 1V 2V 3V 4V 5V 0 6V VADJ (V) www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 7 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver Output Current versus Dimming Voltage (continued) Output Current vs VADJ AMLD-3680IZ ILED (mA) 900 815 800 728 700 600 558 500 400 383 300 218 200 100 73 0 0V 1V 2V 3V 4V 5V 0 6V VADJ (V) Output Current vs VADJ ILED (mA) AMLD-3690IZ 1000 920 900 800 730 700 600 550 500 400 360 300 200 185 100 86 0 0V 1V 2V 3V 4V 5V 0 6V VADJ (V) www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 8 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver Output Current versus Dimming Voltage (continued) Output Current vs VADJ AMLD-36100IZ ILED (mA) 1200 1020 1000 814 800 633 600 453 400 278 200 92 0 0V 1V 2V 3V 4V 5V 0 6V VADJ (V) ILED (mA) 1200 Output Current vs VADJ AMLD-36110IZ 1110 1000 900 800 705 600 517 400 317 200 105 0 0V 1V 2V 3V 4V 5V 0 6V VADJ (V) www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 9 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver Output Current versus Dimming Voltage (continued) Output Current vs VADJ AMLD-36120IZ ILED (mA) 1400 1216 1200 1000 986 797 800 600 591 400 385 200 118 0 0V 1V 2V 3V 4V 5V 0 6V VADJ (V) www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 10 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 11 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 12 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMLD-IZ Up to 2000mA | LED Driver NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com. www.aimtec.com F 051e R12.K Tel: +1 514 620 2722 13 of 13 Toll free: + 1 888 9 AIMTEC (924 6832) North America only