Series AM3GW-Z 3 Watt | DC-DC Converter FEATURES: SIP9 Package Low Ripple and Noise Continuous Short Circuit Protection -40ºC to +85ºC Operating Temperature Range Ultra-Wide Input Range 4:1 1500VDC I/O Isolation Efficiency up to 84% Remote ON/OFF Control Models Single output Model Input Voltage (V) Output Voltage (V) Output Current max (mA) Maximum capacitive load (µF) Efficiency (%) 9-36 9-36 9-36 9-36 18-75 18-75 18-75 18-75 3.3 5 12 15 3.3 5 12 15 700 600 250 200 700 600 250 200 2200 1000 165 100 2200 1000 165 100 77 82 83 83 78 84 84 82 Input Voltage (V) Output Voltage (V) Output Current max (mA) Maximum capacitive load (µF) Efficiency (%) 9-36 9-36 9-36 18-75 18-75 18-75 ±5 ±12 ±15 ±5 ±12 ±15 ±300 ±125 ±100 ±300 ±125 ±100 ±470 ±100 ±47 ±470 ±100 ±47 81 84 83 82 82 83 AM3GW-2403SZ AM3GW-2405SZ AM3GW-2412SZ AM3GW-2415SZ AM3GW-4803SZ AM3GW-4805SZ AM3GW-4812SZ AM3GW-4815SZ Models Dual output Model AM3GW-2405DZ AM3GW-2412DZ AM3GW-2415DZ AM3GW-4805DZ AM3GW-4812DZ AM3GW-4815DZ NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. Input Specifications Parameters Voltage range Filter Start up time Absolute Maximum Rating Peak Input Voltage time On/Off Control Input reflected ripple current Nominal 24 48 Typical Maximum 9-36 18-75 Capacitor 10 Units VDC ms 50 VDC 100 100 ms ON: 0 to 0.6VDC (or open) ; OFF:2.7 to 15.0VDC, OFF idle current: 5mA, max 20 mA p-p 24 48 Isolation Specifications Parameters Tested I/O voltage Resistance Capacitance www.aimtec.com F 051e R11.F Conditions Typical 3 sec >1000 500 Tel: +1 514 620 2722 1 of 5 Rated Units 1500 VDC MOhm pF Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM3GW-Z 3 Watt | DC-DC Converter Output Specifications Parameters Conditions Voltage accuracy Cross Regulation (Dual Output Models) Short Circuit protection Short circuit restart Line voltage regulation Load voltage regulation Ripple & Noise Transient Response Deviation Transient Recovery Time Typical 25% load on one output - 100% load on second load Hiccup Maximum Units ±1 % ±5 % Continuous Auto-Recovery LL~HL ±0.5 From 10% to 100% load ±0.5 From 0% to 100% load 12Vout and 15Vout ±0.5 From 0% to 100% load 3.3Vout and 5Vout ±1 20MHz Bandwidth 50 ±3 300 % % mV p-p % µs General Specifications Parameters Switching frequency Operating temperature Storage temperature Temperature coefficient Maximum case temperature Derating Cooling Humidity Case material Potting Material Weight Dimensions (L x W x H) MTBF Max Soldering Temperature Conditions Typical 100% load 250 Maximum -40 to 85 -40 to +125 ±0.02 100 Above 75°C 3.5 Free Air Convection 95 Non conductive black plastic Epoxy (UL94V-0 rated) 6.5 1.02 x 0.36 x 0.49 inches 25.91 x 9.14 x 12.44 mm >1,212,000 hrs (MIL-HDBK -217F, Ground Benign, t=+25ºC) 1.5mm from case 10 second 260 Units KHz o C o C %/oC o C %/°C % RH g o C Safety Specifications Parameters Agency Approval CE EN55022 Class A, IEC61000-4-2, Perf. Criteria B IEC61000-4-3, Perf. Criteria A IEC61000-4-4, Perf. Criteria B (external 220uF/100V cap required) IEC61000-4-5, Perf. Criteria B (external 220uF/100V cap required) IEC61000-4-6, Perf. Criteria A IEC61000-4-8, Perf. Criteria A NOTE: designed to meet IEC 60950-1:2001 Standards Pin Out Specifications Pin 1 2 3 6 7 8 9 Single - V Input + V Input On/Off Control + V Output NC NC - V Output www.aimtec.com F 051e R11.F Dual - V Input + V Input On/Off Control + V Output Common NC -V Output Tel: +1 514 620 2722 2 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM3GW-Z 3 Watt | DC-DC Converter Dimensions All dimensions are in millimeters (inches) Pin diameter: 1.0 ±0.05 ( 0.04 ±0.002 ) Pin pitch tolerance: ±0.35 ( ±0.014 ) Case Tolerance: ±0.5 ( ±0.02 ) Derating www.aimtec.com F 051e R11.F Tel: +1 514 620 2722 3 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM3GW-Z 3 Watt | DC-DC Converter Test Circuits Conducted Emissions: Models AM2GW-24XX-Z AM2GW-48XX-Z C1 1210,225K/100V,X7R, 2pcs 1210,105k/100V,X7R L1 6.8µH 56µH Input Reflected Ripple current: Lin Cin 12µH 47µF, ESR<1Ω at 100KHz Measurement taken at nominal input and full load. www.aimtec.com F 051e R11.F Tel: +1 514 620 2722 4 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM3GW-Z 3 Watt | DC-DC Converter Control ON/OFF pin connection example: The voltage could be applied trough a limiting resistor. The converter is turned on the external switching circuit is open. NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com. www.aimtec.com F 051e R11.F Tel: +1 514 620 2722 5 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only