C33xx Model 5×7 mm SMD, 3.3V, HCMOS Frequency Range: Frequency Stability Options(ppm): Temperature Range: (standard) (Option “M”) (Option “E”*) Storage: Input Voltage: Input Current: (1.544~34.00 MHz) (35.00~50.00 MHz) (51.00~69.00 MHz) (70.00~156.25 MHz) Standby Current: Output: Symmetry: Rise/Fall Time: (1.54~10.00 MHz) (10.10~30.00 MHz) (30.10~50.00 MHz) (50.10~80.00 MHz) (80.10~156.25 MHz) Logic: Disable Time: Start-up Time: Load: Jitter RMS: 12 kHz~80 MHz Sub-harmonics: Aging: 1.544 to 156.250 MHz ±20, ±25, ±50, ±100 0°C to +70°C -20°C to +70°C -40°C to +85°C -45°C to 90°C 3.3V ±0.3V 18mA Max 25mA Max 30mA Max 50mA Max 3uA Typical, 10uA Max HCMOS 45/55% Max @ 50%Vdd 5nsec Max @ 20% to 80% Vdd 4nsec Max @ 20% to 80% Vdd 3nsec Max @ 20% to 80% Vdd 2.5nsec Max @ 20% to 80% Vdd 2nsec Max @ 20% to 80% Vdd “0”= 10% Vdd Max “1”= 90% Vdd Min 200nSec Max 1mSec Typical, 2mSec Max 30pF Max, >125 MHz 15pF Max 0.5psec Typical, 1psec Max None <3ppm 1st year, <1ppm every year thereafter *available in select frequencies -40/85 Model C33xx is a 1.544 MHz to 156.250 MHz HCMOS Clock Oscillator operating at 3.3Volts. The oscillator utilizes Fundamental or High Q Third Overtone crystal design providing very low Jitter and Phase Noise. No Sub-Harmonics are present in the Output Signal. Applications: Digital Video SONET/SDH/DWDM Storage Area Networks Broadband Access Ethernet, Gigabit Ethernet CRYSTEK CORPORATION Mechanical: Shock: Vibration: Solderability: Solvent Resistance: Resistance to Soldering Heat: MIL-STD-883, Method 2002, Condition B MIL-STD-883, Method 2007, Condition A MIL-STD-883, Method 2003 MIL-STD-202, Method 215 MIL-STD-202, Method 210, Condition I or J Environmental: Thermal Shock: MIL-STD-883, Method 1011, Condition A Moisture Resistance: MIL-STD-883, Method 1004 Specifications subject to change without notice. Rev: L Date: 28-Apr-2015 Page 1 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com C33xx Model 5×7 mm SMD, 3.3V, HCMOS 0.283 (7.20) P/N XXXX Frequency XX 0.204 (5.02) 0.071 (1.80) Denotes pad 1 XXXX=Date Code XX=Lot Code 0.055 Typ. (1.40 Typ.) SUGGESTED PAD LAYOUT #1 #2 #4 #3 0.045 ±0.008 (1.14 ±0.20) 0.200 ±0.005 (5.08 ±0.13) 0.165 (4.19) 0.071 SQ (1.80) 0.200 (5.08) 0.01uF Bypass Capacitor Recommended Dimensions inches (mm) All dimensions are Max unless otherwise specified. Tri-State Function Crystek Part Number Guide Function pin 1 Output pin Open "1" level 0.7×Vcc Min "0" level 0.3×Vcc Max Active Active High Z PIN Function 1 2 3 4 E/D GND OUT Vcc C X 3 3 9 X - 44.736 #1 #3 #1 Temp. Range: Blank = 0/70°C, M= -20/70°C, E= -40/85°C #2 Stability: (see Table 1) #3 Frequency in MHz: 3 or 6 decimal places Example: C3392-44.736MHz = 3.3V, 0/70°C, ±50ppm, 44.736MHz CM3391-44.736MHz = 3.3V, -20/70°C, ±25ppm, 44.736MHz CE3390-44.736MHz = 3.3V, -40/85°C, ±100ppm, 44.736MHz Ramp-Up 3°C/Sec Max. Critical Temperature Zone Ramp-Down 6°C/Sec. 260°C 217°C Stability Indicator 0 2 1 8* pin 4 *available in select frequencies -40/85 Table 1 OUT pin 3 Vcc PWR Supply ± 100ppm ± 50ppm ± 25ppm ± 20ppm TEST CIRCUIT mA M RECOMMENDED REFLOW SOLDERING PROFILE TEMPERATURE #2 VM Bypass Cap. OSC. E/D 200°C pin 1 O/P Load incl Probe Cl OUT GND pin 2 150°C High Impedance GND or "LOW" Preheat 180 Secs. Max. 8 Minutes Max. Oscillation OPEN or "HIGH" 90 Secs. Max. 260°C for 10 Secs. Max. NOTE: Reflow Profile with 240°C peak also acceptable. CRYSTEK CORPORATION Specifications subject to change without notice. Rev: L Date: 28-Apr-2015 Page 2 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com