CVPD-034 LVPECL Voltage Controlled Crystal Oscillator 5×7mm SMD 3.3 Volts 5×7mm SMD Actual CVPD-034X-50-155.520 MHz Plot Applications: Digital Video SONET/SDH/DWDM Storage Area Networks Broadband Access Ethernet, Gigabit Ethernet Rev: X Date: 24-Sep-2014 Page 1 of 3 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com CVPD-034 LVPECL Voltage Controlled Crystal Oscillator 5×7mm SMD 3.3 Volts Frequency Range: 77.760 MHz to 200.000 MHz Frequency Pulling (APR*) Min.: ±50ppm Temperature Range: (standard) (Option M) (Option X) Storage: 0°C to +70°C -20°C to +70°C -40°C to +85°C -45°C to 90°C Input Voltage: Control Voltage: Input Current: 3.3V ±5% 1.65V ±1.65V 55mA Typical, 88mA Max Output: Symmetry: Rise/Fall Time: Linearity: Differential LVPECL 45/55% Max @ zero crossing point 1nSec Max (20% to 80%) ±10% Max Logic: Terminated to Vdd-2V into 50 Ω “0”=1.490 Min, 1.680 Max Temp. 0°C to 85°C “1”=2.275 Min, 2.420 Max “0”=1.490 Min, 1.745 Max Temp. -40°C to 0°C “1”=2.215 Min, 2.420 Max 200nSec Max Disable Time: 20uSec Max Enable Time: Phase Jitter: 12kHz~80MHz 0.5pSec Typical, 1pSec RMS Max Phase Noise: 10Hz 100Hz 1kHz 10kHz 100kHz -70dBc/Hz Typical -98dBc/Hz Typical -125dBc/Hz Typical -145dBc/Hz Typical -149dBc/Hz Typical Sub-harmonics: None Aging: <5ppm 1st year, <2ppm every year thereafter * Inclusive of calibration, frequency stability, and aging CRYSTEK CORPORATION Rev: X Date: 24-Sep-2014 Page 2 of 3 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com CVPD-034 LVPECL Voltage Controlled Crystal Oscillator 5×7mm SMD 3.3 Volts Crystek Part Number Guide CVPD - 034 X - 50 - 155.520 #1 #2 #3 #4 Standard Frequencies #5 #1 Crystek PECL VCXO #2 Model 034 #3 Temp Range: Blank = 0/70°C, M = -20/70°C, X = -40/85°C #4 Pullability: (see Table 1) #5 Frequency in MHz: 3 or 6 decimal places (±50ppm, 0/70°C) 77.760 MHz 155.520 MHz 156.250 MHz 161.132800 MHz 200.000 MHz Pullability Indicator 50 ± 50ppm Table 1 Example: CVPD-034X-50-155.520 3.3V, -40/85°C, ±50ppm (APR), 155.520 MHz RECOMMENDED REFLOW SOLDERING PROFILE Ramp-Up 3°C/Sec Max. Shock: Solderability: Vibration: Solvent Resistance: Resistance to Soldering Heat: Environmental: Thermal Shock: Moisture Resistance: TEMPERATURE Mechanical: MIL-STD-883, Method 2002, Condition B MIL-STD-883, Method 2003 MIL-STD-883, Method 2007, Condition A MIL-STD-202, Method 215 MIL-STD-202, Method 210, Condition I or J Critical Temperature Zone Ramp-Down 6°C/Sec. 260°C 217°C 200°C 150°C Preheat 180 Secs. Max. 8 Minutes Max. MIL-STD-883, Method 1011, Condition A MIL-STD-883, Method 1004 90 Secs. Max. 260°C for 10 Secs. Max. NOTE: Reflow Profile with 240°C peak also acceptable. 0.274 ±0.007 (6.96 ±0.18) Dimensions inches (mm) All dimensions are Max unless otherwise specified. Part Number Frequency DC Lot Code 0.193 ±0.007 (4.90 ±0.18) Tristate Function Function pin 2 Output pin Open or N/C "1" level 0.7×Vdd Min "0" level 0.3×Vdd Max Active Active High Z 0.071 (1.80) Denotes pad 1 SUGGESTED PAD LAYOUT via to ground 0.01µF 0.055 Typ (1.40 Typ) 0.071 SQ (1.80) 0.045 ±0.008 (1.14 ±0.20) #1 #2 #3 #6 #5 #4 0.100 (2.54) 0.200 (5.08) CRYSTEK CORPORATION 0.148 (3.75) 0.200 (5.08) 0.01uF Bypass Capacitor Recommended PIN Connection 1 2 3 4 5 6 Volt Control Enable/Disable GND Output Comp Output Vcc Rev: X Date: 24-Sep-2014 Page 3 of 3 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com