PM-9G Description PM-9G Power Supply and Battery Charger The Gamewell-FCI, PM-9G Power Supply is a 220/240 VAC, 50/60 Hz switching power supply. It provides power to the Fire Alarm Control Panel, INCC Command Center, INX Transponder assemblies, and all the E3 Series® components. The PM-9G is a component of the following systems. • E3 Series Expandable Emergency Evacuation System • E3 Series Combined Fire Alarm and Mass Notification Systems • E3 Series Broadband Voice Evacuation System • NetSOLO® System It includes 9 amperes of filtered and regulated 24 VDC FWR. In addition, it has an internal battery charging circuit that is capable of maintaining up to 55 A/H batteries. Installation Typically, the PM-9G Module can be mounted in the following E3 Series cabinets: • Cabinet B, Fire Alarm Control Panel • Cabinet C, Command Center • Cabinet C, Transponder • Cabinet D, Command Center • Cabinet D, Transponder For information on the PM-9G installation, refer to the following documents: - E3 Series Installation/Operation Manual, P/N: 9020-0574 - PM-9G Installation Instructions, P/N: 9001-0055 - Mass Notification System Installation/Operation Manual, P/N: LS10013-000GF-E. PM-9G Features • Listed under UL® Standard 864, 9th Edition • Listed under UL Standard UL2572 for Mass Notification • Includes 9 ampere, filtered, regulated power supply • Provides 1 ampere battery charging current • Offers energy and space saving switching technology • Contains an integral battery charger capable of recharging up to 55 A/H batteries (Batteries not furnished) Specifications Input Voltage: Input Current: Output Voltage: Output Current: Output Current: Output Current: 220/240 VAC @ 50/60 Hz 2.4 amps max. 24 VDC FWR 9 amperes Alarm max. continuous 5 amps max. continuous Standby (when the PM-9G is used with the ILIE3 or the ILI95-E3 Series) (See Note 1) 4 amps max. continuous Standby (when the PM-9G is used with any AM-50 Series amplifier) (See Note 1) 1 amp battery charging current 0.050 amp Output Current: Alarm Current: Operating Temperature: 32° to 120° F (0° to 49° C) Relative Humidity: 0 to 93% (non-condensing) at 90° F (32° C) Dimensions: 27 W x 13 H x 5 D cm (10 1/2” W x 5” H x 2” D) Supervised and Non Class 2 Power-Limited Note 1: Continuous standby loads in excess of .560 Amps up to 5 Amps or 4 Amps may require a Generator Backup or load shedding during an AC power failure. Ordering Information Part Number PM-9G 29229 ® ® E3 Series and NetSOLO are registered trademarks of Honeywell International Inc. ® UL is a registered trademark of Underwriters Laboratories Inc. Description Power supply and battery charger AC Line Filter Kit SIGNALING MEA Approved S1869 Vol. 14 FDNY: 7165-1703:0125 S1949 Vol. 19 COA #6077 GAMEWELL-FCI 12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118 Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use. www.gamewell-fci.com 9021-60391 Rev. H page 1 of 1 ©2013 by Honeywell International Inc. All rights reserved.