H HiTRON 18-36VDC/36-72VDC INPUT RANGE DC-DC CONVERTER HOT-SWAP CompactPCI QUAD OUTPUT 250 WATTS ACTIVE CURRENT SHARING SWITCHING POWER SUPPLIES HDC250P-24B/48B SERIES FEATURES: 250W 3U X 8HP EUROCARD PACKAGE 36-72VDC NOMINAL 48VDC INPUT INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE THIRD-WIRE CURRENT SHARING EMI MEET EN 55022 / FCC CLASS B CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Voltage: Typ. 18-36Vdc,nominal input 24Vdc. Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 250W continuous. Output Connector: Positronic 47-pin PCIH47M400A1. Line Regulation: Typ. 0.1%. Load Regulation: Typ. ±2.0%. Noise & Ripple: Typ. 1% Pk.-Pk. or 50mV, whichever is greater. OVP: Built-in at all outputs. Adjustability: Available at VO1, 2 & 3. Output Trim: Electrical trim available at VO1/2.[ADJ #] Remote Sensing: Available at VO1,VO2 & VO3. Hot-Swap: Available. N+1 Redundancy: Installed with internal OR-ing diodes at all outputs for N+1 redundancy operation. Current Sharing: Third-wire current sharing at VO1,2&3. Power OK Signal: Available for all outputs. Over Current Protection (OCP): Installed in each rail. Overload Protection (OLP): Fully protected against output overload or short circuit. Typical 120% max. load. Consult the factory for special OLP setting. Typ. 36-72Vdc,nominal input 48Vdc. Input Connector: Positronic 47-pin PCIH47M400A1. Inrush Current: Peak 32.6A at nominal 24Vdc. Typ. 20A at nominal 48Vdc. Input Current: 13.7A at nominal input 24Vdc. 6.6A at nominal input 48Vdc. Dielectric Withstand: Meet IEC 60950-1 regulation. EMI: Meet EN 55022 / FCC Class B. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: <Green> means valid input voltage. <Amber> means a critical fault. Thermal Protection (OTP): Installed NTC for thermal sensor at [DEG#] pin. GENERAL SPECIFICATION Efficiency: Typ. 74%-77 %. Switching Frequency: 120K Hz. Circuit Topology: Forward circuit. Transient Response: Peak transient less than 100mV and recovers within 2mS for 25% load-change. Safety Standard: IEC 60950-1 Class I. Construction: Eurocard 3U X 8HP X 160mm CompactPCI format. Front panel with either Ordinary handle or Extractor handle. Operating Temperature: 0 to +50 °C at full load with specified air flow. Derates linearly to 50% at +70°C. Storage Temperature: -40 to +85 °C. Temperature Coefficient: Typ. ±0.02% / °C. Cooling: At least 16CFM(500LFM) moving air is required to achieve full rating power 250W in a confined area. Power Density: 4.58 Watts/ Cubic Inch. NOTE: (1)All measurement are at nominal input, full load and +25°C unless otherwise specifications. (2)Due to requests in market and advances in technology, specifications subject to change without notification. For the details of safety approval, please consult the factory. -101- OUTPUT VOLTAGE / CURRENT RATINGS CHART QUAD OUTPUT MAIN +VO1 @★#≡⊙ MODEL NO. AUX. +VO2 ▲@★#≡⊙ Min. Typ. Volt. Max. Min HDC250P-24B-490(E) 2A Typ Volt. Max Pk. Min. Typ. Volt. Max. Pk. 18A +3.3V 33A 5A +12V 5.5A 6A 0A 0.5A -12V 1A 1.5A +5V +5V 33A 0A 18A +3.3V 33A 0A 5A +12V 5.5A 6A 0A 0.5A -12V 1A 1.5A +5V 33A 0A 18A +3.3V 33A 0A 5A +12V 5.5A 6A 0A 0.5A -12V 1A 1.5A HDC250P-48B-490(E) 2A 25A 2A 25A 0A AUX. -VO4 ●⊙■★= Volt. Max. Min. 25A HDC250P-48B-490(O) 33A AUX. +VO3 ▲@★#≡⊙ Typ. 0A Symbol: "★" OVP built-in. "@" Adjustable. "#" Remote sensing. "≡" 3rd wire Load Sharing. "⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post-regulator. "■" Common Choke. Remark: Peak load less than 60sec. with duty cycle <10%. Max. load is the continuous operating load of each rail. But the max. load of each rail can't be drawn from all outputs at the same time. MECHANICAL DIMENSIONS: MM [INCHES] WEIGHT: 666.0 g (23.5 Oz.) HDC250P-24B/48B-490(E) HDC250P-48B-490(O) INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT DC INPUT ASSIGNMENT -Vin +Vin G CNTR &PIN # 47 46 45 QUAD OUTPUT VO1 S+ S- Adj. C.S. 1,2, 3,4 30 34 29 35 VO2 13,14, 15,16, 17,18 S+ 33 Adj. C.S. 32 Mating connector: PCIH47F400A1. -102- 41 STATUS/CONTROL VO3 S+ C.S VO4 20 36 44 21 DC COM EN# 5,6,7,8,9, 10,11,12, 27 19,22,24 DEG# 38 INH# FAL# 39 42