T-1 (3mm) BLINKING LED LAMP Part Number: WP36BSRD/B Super Bright Red ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Features Descriptions z T-1 package with rectangular base. z The Super Bright Red source color devices are made with Gallium Aluminum Arsenide Red Light Emitting z With built-in blinking IC. z Operation voltage from 3.5V to 14V. z Blinking frequency from 3.0Hz to 1.5Hz. Diode. z Electrostatic discharge and power surge could damage the LEDs. z RoHS compliant. z It is recommended to use a wrist band or antielectrostatic glove when handling the LEDs. z All devices, equipments and machineries must be electrically grounded. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAF2690 REV NO: V.7A DATE: JAN/26/2015 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: P.Cheng ERP: 1101003793 Selection Guide Part No. Dice Super Bright Red (GaAlAs) WP36BSRD/B Iv (mcd) V= 9V Lens Type Red Diffused Viewing Angle [1] Min. Typ. 120 320 *40 *100 2θ1/2 60° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. * Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Min. Typ. λpeak Peak Wavelength Super Bright Red 655 nm λD Dominant Wavelength Super Bright Red 640 nm Δλ1/2 Spectral Line Half-width Super Bright Red 20 nm IF Forward Current Super Bright Red 22 mA Min:VF=3.5V Typ:VF=5V ISON Supply Current Super Bright Red 8 mA VF=3.5V ISON Supply Current Super Bright Red 44 mA VF=14V f Blink Frequency Super Bright Red Hz VF=3.5V~14V 8 Max. 1.5 3 Units Test Conditions Notes: 1.Wavelength value is traceable to the CIE127-2007 compliant national standards. 2.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25°C Parameter Super Bright Red Units Power dissipation 310 mW Forward Voltage 14 V Reverse Voltage 0.5 V Operating Temperature -40°C To +70°C Storage Temperature -40°C To +85°C Lead Solder Temperature [1] 260°C For 3 Seconds Lead Solder Temperature [2] 260°C For 5 Seconds Notes: 1. 2mm below package base. 2. 5mm below package base. SPEC NO: DSAF2690 REV NO: V.7A DATE: JAN/26/2015 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: P.Cheng ERP: 1101003793 Super Bright Red WP36BSRD/B SPEC NO: DSAF2690 REV NO: V.7A DATE: JAN/26/2015 PAGE: 3 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: P.Cheng ERP: 1101003793 PACKING & LABEL SPECIFICATIONS WP36BSRD/B Terms and conditions for the usage of this document 1. The information included in this document reflects representative usage scenarios and is intended for technical reference only. 2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. Before production usage customer should refer to the latest datasheet for the updated specifications. 3. When using the products referenced in this document, please make sure the product is being operated within the environmental and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible for any subsequent issues. 4. The information in this document applies to typical usage in consumer electronics applications. If customer's application has special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with Kingbright representative for further assistance. 5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright. 6. All design applications should refer to Kingbright application notes available at http://www.KingbrightUSA.com/ApplicationNotes SPEC NO: DSAF2690 REV NO: V.7A DATE: JAN/26/2015 PAGE: 4 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: P.Cheng ERP: 1101003793 SPEC NO: DSAF2690 REV NO: V.7A DATE: JAN/26/2015 PAGE: 5 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: P.Cheng ERP: 1101003793 SPEC NO: DSAF2690 REV NO: V.7A DATE: JAN/26/2015 PAGE: 6 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: P.Cheng ERP: 1101003793