HT82B42R USB Test Report (TID: 40001338)

USB-IF COMPLIANCE PROGRAM
USB 2.0 Test Report
For
Low Speed Device
Company Name:
VID (Dec or Hex):
Model Name:
Product Type:
Report Date:
Holtek Semiconductor
1241 The VID for the company who applies the USB-IF logo.
HT82B42R
HID
2011/12/09
Test Result: PASS
Tester:
Caspar Lin
Authorized Signature:
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
1/10
USB-IF COMPLIANCE PROGRAM
Legal Disclaimer
1.
TEST RESULT IS VALID ONLY TO THE ORIGINAL TESTED DEVICE MODEL. ALLION
RESERVES THE RIGHT TO PROHIBIT OTHERS TO DISTORT, ISOLATE, FALSIFY,
COPIED AND/OR BY ANY PROCESS TO CHANGE THE CONTENT OF THIS TEST
REPORT UNLESS IT IS PRIOR APPROVED BY ALLION.
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
2/10
USB-IF COMPLIANCE PROGRAM
Legacy USB Compliance Tests
Frameworks Test Result (USB20CV):
Pass
Fail
This test primarily covers USB-IF testing of devices and hubs for compliance with the standard
commands in Chapters 9 and 11 of the USB 2.0 specification. This specification does not
describe the full set of USB-IF tests and assertions for these devices.
VID: 04d9
Chapter 9:
PID: 0355
Pass
Fail
Interface: 1 MAX Power: 100 mA
HID:
Pass
Remote Wakeup: Yes
Fail
N/A
Frameworks Test Result (USB30CV with Renesas xHCI Host Controller):
Pass
Fail
All USB peripherals are required to enumerate on a SuperSpeed host controller and pass all
applicable tests within USB30CV. Failure framework test in USB30CV will prevent certification.
VID: 04d9
Chapter 9:
PID: 0355
Pass
Fail
Interface: 1 MAX Power: 100 mA
HID:
Pass
Remote Wakeup: Yes
Fail
N/A
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
3/10
USB-IF COMPLIANCE PROGRAM
Power Current Test Result:
Pass
Fail
Power Type: Low Powered Device
Operating Power: 8.03 mA
(<= Max Power <= 100mA for Low Power)
(<= Max Power <= 100mA for Self Power)
(<= Max Power <= 500mA for High Power)
Unconfiguration Power: 8.03 mA
(<= 100mA)
Configuration Power: 8.02 mA
(<= Max Power <= 100mA for Low Power)
(<= Max Power <= 500mA for High Power)
Suspend Mode Power: N/A uA
(Remote Wakeup Unsupported Device Only)
(Remote Wakeup Supported Device=> Type “N/A”)
(<= 2500uA for Self Power Hub and Non Compound Device)
(<= 12500uA for Bus Power Hub and Compound Device)
Suspend Mode Power with Remote Wakeup: 344 uA
Suspend Mode Power without Remote Wakeup: 344 uA
(Remote Wakeup Supported Device Only)
(Remote Wakeup Unsupported Device => Type “N/A”)
(<= 2500uA for Self Power Hub and Non Compound Device)
(<= 12500uA for Bus Power Hub and Compound Device)
Suspend Port Power: 342 uA
(<= 2500uA for not Supporting USB Battery Charging)
(<= 100mA for Supporting USB Battery Charging)
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
4/10
USB-IF COMPLIANCE PROGRAM
Interoperability Test Overall Result:
Pass
Fail
EHCI Host Controller:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Enumeration and Driver installation:
Check operation of device
Interoperability – Operate all devices:
Hot plug test – A Plug
Hot plug test – B Plug
Warm Boot test
Remote Wake-up Test
S3 Active Standby Test
S3 Active Standby Resume Test
Root Port Test
S4 Active Hibernate Test
S4 Active Hibernate Resume Test
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Pass
Pass
Pass
Fail
Fail
Fail
Pass
Pass
Pass
Fail
Fail
Fail
N/A
N/A
UHCI Host Controller:
13. Interoperability – Operate all devices:
14. System Suspend/Resume Test– Operate DUT
15. Warm Boot Test – Operate DUT
OHCI Host Controller:
16. Interoperability – Operate all devices:
17. System Suspend/Resume Test – Operate DUT
18. Warm Boot Test – Operate DUT
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
5/10
USB-IF COMPLIANCE PROGRAM
Low Signal Quality Test Result:
Pass
Fail
Connector Type: Untethered (Tethered means no standard B or special B connector)
Low Speed Upstream Signal Quality:
Pass
Fail
Inrush Current Test:
Pass
Fail
Back Voltage Test Result: (Enumerate before/after)
Pass
Fail
D+: 0 mV / 0 mV
D- : 0 mV / 0 mV
VBus: 0 mV / 0 mV
(All values <= 400mV)
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
6/10
USB-IF COMPLIANCE PROGRAM
More Detail Test Result:
1. Low Speed Upstream Signal Quality: Pass









Overall result: pass!
Signal eye:
eye passes
EOP width: 1.33 us
EOP width passes
Measured signaling rate: 1.5014 MHz
signal rate passes
Edge Monotonicity: 60 mV
Monotonic Edge passes
Crossover voltage range: 1.63 V to 1.75 V, mean crossover 1.69 V
(first crossover at 1.67 V, 10 other differential crossovers checked)
crossover voltages pass
Consecutive jitter range: -1.959 ns to 2.642 ns, RMS jitter 1.798 ns
Paired JK jitter range: -1.732 ns to 0.344 ns, RMS jitter 1.248 ns
Paired KJ jitter range: -0.133 ns to 0.152 ns, RMS jitter 0.113 ns
jitter passes
Additional Information



Rising Edge Rate: 19.50 V/us (Equivalent risetime = 135.40 ns)
(minimum 8.80 V/us, maximum 35.20 V/us)
Falling Edge Rate: 16.41 V/us (Equivalent falltime = 160.87 ns)
(minimum 8.80 V/us, maximum 35.20 V/us)
Edge Rate Match: 18.81% (limit +/-20%)
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
7/10
USB-IF COMPLIANCE PROGRAM
SignalData and Eye
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
8/10
USB-IF COMPLIANCE PROGRAM
2. Inrush Current: Pass




Overall result: pass!
Inrush at 5.000 V: 41.6795 C
Inrush passes
Region 1 Start: 0.00126 ms - End: 0.156 ms = 41.68 C
Region 2 Start: 41.716 ms - End: 41.816 ms = 0.01116 C
Hot Plug (Attach) Current Draw
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
9/10
USB-IF COMPLIANCE PROGRAM
Notice: Test result is valid only to the original tested device model. The content
of test report may not be copied or re-transmitted (except for the entire report)
unless it is prior approved by Allion.
Test Procedure Reference:
1. USB-IF Compliance Update Page---Interoperability Gold Tree Update
http://compliance.usb.org/resources/GoldSuite%20Test%20Procedure.pdf
2. Universal Serial Bus Implementers Forum Full and Low Speed Electrical and
Interoperability Compliance Test Procedure, version: 1.3
Project ID: UNC-HOK-USB-034_2
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
10/10