USB-IF COMPLIANCE PROGRAM USB 2.0 Test Report For Full Speed Device Company Name: VID (Dec or Hex): Holtek Semiconductor 1241 The VID for the company who applies the USB-IF logo. Model Name: HT82A824R Product Type: Audio Class Report Date: 2011/08/09 Test Result: PASS Tester: William Tsao Authorized Signature: Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 1/10 USB-IF COMPLIANCE PROGRAM Legal Disclaimer 1. TEST RESULT IS VALID ONLY TO THE ORIGINAL TESTED DEVICE MODEL. ALLION RESERVES THE RIGHT TO PROHIBIT OTHERS TO DISTORT, ISOLATE, FALSIFY, COPIED AND/OR BY ANY PROCESS TO CHANGE THE CONTENT OF THIS TEST REPORT UNLESS IT IS PRIOR APPROVED BY ALLION. Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 2/10 USB-IF COMPLIANCE PROGRAM Legacy USB Compliance Tests Frameworks Test Result (USB20CV): Pass Fail This test primarily covers USB-IF testing of devices and hubs for compliance with the standard commands in Chapters 9 and 11 of the USB 2.0 specification. This specification does not describe the full set of USB-IF tests and assertions for these devices. VID: 04d9 Chapter 9: PID: 2824 Pass Fail Interface: 3 MAX Power: 500 mA Remote Wakeup: N/A MSC: Pass Fail N/A UVC: Pass Fail N/A HID: Pass Fail N/A Frameworks Test Result (USB30CV with Renesas xHCI Host Controller): Pass Fail All USB peripherals are required to enumerate on a SuperSpeed host controller and pass all applicable tests within USB30CV. Failure framework test in USB30CV will prevent certification VID: 04d9 Chapter 9: PID: 2824 Pass Fail Interface: 3 MAX Power: 500 mA Remote Wakeup: N/A MSC: Pass Fail N/A UVC: Pass Fail N/A HID: Pass Fail N/A Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 3/10 USB-IF COMPLIANCE PROGRAM Power Current Test Result: Pass Fail Power Type: High Powered Device Operating Power: 70.22 mA (<= Max Power <= 100mA for Low Power) (<= Max Power <= 100mA for Self Power) (<= Max Power <= 500mA for High Power) Unconfiguration Power: 27.33 mA (<= 100mA) Configuration Power: 26.94 mA (<= Max Power <= 100mA for Low Power) (<= Max Power <= 500mA for High Power) Suspend Mode Power: 354.68 uA (Remote Wakeup Unsupported Device Only) (Remote Wakeup Supported Device=> Type “N/A”) (<= 2500uA for Self Power Hub and Non Compound Device) (<= 12500uA for Bus Power Hub and Compound Device) Suspend Mode Power with Remote Wakeup: N/A uA Suspend Mode Power without Remote Wakeup: N/A uA (Remote Wakeup Supported Device Only) (Remote Wakeup Unsupported Device => Type “N/A”) (<= 2500uA for Self Power Hub and Non Compound Device) (<= 12500uA for Bus Power Hub and Compound Device) Suspend Port Power: 353.62 uA (<= 2500uA for not Supporting USB Battery Charging) (<= 100mA for Supporting USB Battery Charging) Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 4/10 USB-IF COMPLIANCE PROGRAM Interoperability Test Overall Result: Pass Fail EHCI Host Controller: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Enumeration and Driver installation Check operation of device Interoperability – Operate all devices: Hot plug test – A Plug Hot plug test – B Plug Warm Boot test Remote Wake-up Test S3 Active Standby Test S3 Active Standby Resume Test Root Port Test S4 Active Hibernate Test S4 Active Hibernate Resume Test Pass Pass Pass Pass Pass Pass Pass Pass Pass Pass Pass Pass Fail Fail Fail Fail Fail Fail Fail Fail Fail Fail Fail Fail Pass Pass Pass Fail Fail Fail Pass Pass Pass Fail Fail Fail N/A N/A UHCI Host Controller: 13. Interoperability – Operate all devices 14. System Suspend/Resume Test– Operate DUT 15. Warm Boot Test – Operate DUT OHCI Host Controller: 16. Interoperability – Operate all devices 17. System Suspend/Resume Test – Operate DUT 18. Warm Boot Test – Operate DUT Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 5/10 USB-IF COMPLIANCE PROGRAM Full Signal Quality Test Result: Pass Fail Connector Type: Untethered (Tethered means no standard B or special B connector) Full Speed Upstream Signal Quality: Pass Fail Inrush Current Test: Pass Fail Back Voltage Test Result: (Enumerate before/after) Pass Fail D+: 0 mV / 0 mV D- : 0 mV / 0 mV VBus: 0 mV / 0 mV (All values <= 400mV) Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 6/10 USB-IF COMPLIANCE PROGRAM More Detail Test Result: 1. Full Speed Upstream Signal Quality: Pass Overall result: pass! Signal eye: eye passes EOP width: 167.34 ns EOP width passes Measured signaling rate: 12.0034 MHz signal rate passes Edge Monotonicity: 68 mV Monotonic Edge passes Crossover voltage range: 1.44 V to 1.65 V, mean crossover 1.54 V (first crossover at 1.65 V, 10 other differential crossovers checked) crossover voltages pass Consecutive jitter range: -161.436 ps to 266.980 ps, RMS jitter 143.289 ps Paired JK jitter range: -16.521 ps to 8.867 ps, RMS jitter 13.258 ps Paired KJ jitter range: -289.285 ps to 298.283 ps, RMS jitter 214.487 ps jitter passes Additional Information Rising Edge Rate: 297.56 V/us (Equivalent risetime = 8.87 ns) (minimum 132.00 V/us, maximum 660.00 V/us) Falling Edge Rate: 283.79 V/us (Equivalent falltime = 9.30 ns) (minimum 132.00 V/us, maximum 660.00 V/us) Edge Rate Match: 4.85% (limit +/-10%) Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 7/10 USB-IF COMPLIANCE PROGRAM SignalData and Eye Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 8/10 USB-IF COMPLIANCE PROGRAM 2. Inrush Current: Pass Overall result: pass! Inrush at 5.000 V: 25.9327 C Inrush passes Region 1 Start: 0.00103 ms - End: 0.117 ms = 25.93 C Region 2 Start: 49.070 ms - End: 49.180 ms = 0.02928 C Region 3 Start: 49.738 ms - End: 49.851 ms = 2.953 C Hot Plug (Attach) Current Draw Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 9/10 USB-IF COMPLIANCE PROGRAM Notice: Test result is valid only to the original tested device model. The content of test report may not be copied or re-transmitted (except for the entire report) unless it is prior approved by Allion. Test Procedure Reference: 1. USB-IF Compliance Update Page---Interoperability Gold Tree Update http://compliance.usb.org/resources/GoldSuite%20Test%20Procedure.pdf 2. Universal Serial Bus Implementers Forum Full and Low Speed Electrical and Interoperability Compliance Test Procedure, version: 1.3 Project ID：UNC-HOK-USB-032_1 © Allion Test Labs, Inc. All rights reserved. 9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C. Phone: +886-2-77228800 Fax: +886-2-26557879 10/10