TVS Diode Arrays (SPA™ Family of Products) Lightning Surge Protection - SP03A-3.3 Series SP03A-3.3 Series 3.3V 150A Diode Array RoHS Pb GREEN This SP03A provides overvoltage protection for applications such as 10/100/1000 BaseT Ethernet, and T3/E3 interfaces. This new protector combines the TVS diode element with a diode rectifier bridge to provide both longitudinal and differential protection in one package. This design results in a capacitive loading characteristic that is log-linear with respect to the signal voltage across the device. This reduces intermodulation (IM) distortion caused by a typical solid-state protection solution. The application schematic provides the connection information and the SP03A is rated for GR-1089, intra-building transient immunity requirements for telecommunication installations. Pinout Features t 40*$TVSGBDFNPVOU package (JEDEC MS-012) t -JHIUOJOH1SPUFDUJPO IEC61000-4-5, 150A (tp=8/20μs) 1 8 2 7 t &'5*&$" (tp=5/50ns) t -PXJOTFSUJPOMPTTMPH linear capacitance 6 3 4 t $MBNQJOHTQFFEPG nanoseconds t 6-7FQPYZNPMEJOH t -PXDMBNQJOHWPMUBHF 5 t $PNCJOFEMPOHJUVEJOBM and metallic protection t 3P)4DPNQMJBOU SOIC-8 (Top View) Functional Block Diagram Applications t 5&-JOFDBSET t 5&BOE%4*OUFSGBDFT Line in Pin 1 and 8 t #BTF5 Ethernet t 454*OUFSGBDFT Line out Application Example TeleLink (0461 1.25) SP03A-3.3BTG Pin 2, 3, 6, and 7 Line out Line in Pin 4 and 5 8 2 7 3 6 4 5 to chipset (Ethernet PHY, T3/E3 PHY, etc.) This schematic shows a high-speed data interface protection solution. The SP03A-3.3BTG is compatible with the intra-building surge requirements of Telcordia’s GR-1089-CORE, and the Basic Level Recommendations of ITU K.20 and K.21. The TeleLink fuse provides overcurrent protection for the long term 50/60 Hz power fault events. Life Support Note: Not Intended for Use in Life Support or Life Saving Applications The products shown herein are not designed for use in life sustaining or life saving applications unless otherwise expressly indicated. ©2012 Littelfuse, Inc. Specifications are subject to change without notice. Please refer to www.littelfuse.com/SPA for current information. 1 131 Revision: March 20, 2012 SP03A-3.3 Series SP03A-3.3 Description TVS Diode (SPA™of Family of Products) TVS Diode ArraysArrays (SPA™ Family Products) Surge Protection - SP03A-3.3 LightningLightning Surge Protection - SP03-3.3 SP03A-3.3 Series Series Series Thermal Information Rating Units Peak Pulse Current (8/20μs) Parameter 150 A SOIC Package Peak Pulse Power (8/20μs) 3300 W Operating Temperature Range IEC 61000-4-2, Direct Discharge, (Level 4) 30 kV Storage Temperature Range -65 to 150 °C IEC 61000-4-2, Air Discharge, (Level 4) 30 kV Maximum Junction Temperature 150 °C IEC 61000-4-5 (8/20μs) 150 A °C 100 A Maximum Lead Temperature (Soldering 20-40s) (SOIC - Lead Tips Only) 260 Telcordia GR 1089 (Intra-Building) (2/10μs) ITU K.20 (5/310μs) 40 A Parameter Rating Units 170 °C/W -55 to 125 °C CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Electrical Characteristics (TOP = 25°C) Parameter Symbol Test Conditions Min Typ Max Units VRWM IT≤1μA - - 3.3 V Reverse Breakdown Voltage VBR IT= 2μA 3.3 - - V Snap Back Voltage VSB IT= 50mA 3.3 - - V Reverse Leakage Current IR VRWM= 3.3V, T= 25°C - - 1 μA Clamping Voltage, Line-Ground VC IPP= 50A, tp=8/20 μs - - 13 V Reverse Stand-Off Voltage VC IPP= 100A, tp=8/20 μs - - 17 V RDYN (VC2-VC1)/(IPP2-IPP1) - 0.15 - Ω Clamping Voltage, Line-Line VC IPP= 50A, tp=8/20 μs - - 15 V Clamping Voltage, Line-Line VC IPP= 100A, tp=8/20 μs - - 20 V RDYN (VC2-VC1)/(IPP2-IPP1) - 0.25 - Ω Between I/O Pins and Ground VR=0V, f= 1MHz - 9 12 pF Between I/O Pins VR=0V, f= 1MHz - 4.5 6 pF Clamping Voltage, Line-Ground Dynamic Resistance, Line-Ground Dynamic Resistance , Line-Line Junction Capacitance Cj Figure 1: Non-repetitive Peak Pulse Current vs. Pulse Time Figure 2: Current Derating Curve 120 Percentage of Rated Current (%IP) Peak Pulse Current (A) 1000 100 10 1 1 10 100 80 60 40 20 0 1000 0 20 40 60 80 100 120 140 160 Ambient Temperature (C) Pulse decay time (μs) SP03A-3.3 Series 100 132 Revision: March 20, 2012 ©2012 Littelfuse, Inc. Specifications are subject to change without notice. Please refer to www.littelfuse.com/SPA for current information. SP03A-3.3 Absolute Maximum Ratings TVS Diode ArraysArrays (SPA™ Family of Products) TVS Diode (SPA™ Family of Products) LightningLightning Surge Protection - SP03A-3.3 Series Series Surge Protection - SP03-3.3 SP03A-3.3 Series Figure 4: Clamping Voltage vs. Peak Pulse Current 18 100% 16 90% 14 Clamp Voltage-VC(V) 110% Percent of IPP 80% 70% 60% 50% 40% Line to Line 12 10 8 Line to Ground 6 4 30% 2 20% 0 10% 0 10 20 30 0% 0.0 5.0 10.0 15.0 20.0 25.0 SP03A-3.3 Figure 3: Pulse Waveform 40 50 60 70 80 90 100 Peak Pulse Current-I PP (A) 30.0 Time (μs) Figure 5: Capacitance vs. Reverse Voltage Figure 6: Forward Voltage vs. Forward Current 10 7 Line to Ground 9 6 Ground-to-Line Forward Voltage (V) Capacitance (pF) 8 7 6 5 4 Line to Line 3 2 5 4 3 2 1 1 0 0 0.0 0.5 1.0 1.5 2.0 2.5 3.0 0 10 20 30 Bias Voltage (V) 40 50 60 70 80 90 100 Forward Current (A) Soldering Parameters Reflow Condition Pb – Free assembly tP Pre Heat - Temperature Min (Ts(min)) 150°C - Temperature Max (Ts(max)) 200°C - Time (min to max) (ts) 60 – 180 secs Average ramp up rate (Liquidus) Temp (TL) to peak 3°C/second max TS(max) to TL - Ramp-up Rate 3°C/second max Reflow - Temperature (TL) (Liquidus) 217°C - Temperature (tL) 60 – 150 seconds TL TS(max) tL Ramp-do Ramp-down Preheat TS(min) tS time to peak temperature +0/-5 Critical Zone TL to TP Ramp-up 25 Peak Temperature (TP) 260 Time within 5°C of actual peak Temperature (tp) 20 – 40 seconds Ramp-down Rate 6°C/second max Time 25°C to peak Temperature (TP) 8 minutes Max. Do not exceed 260°C ©2012 Littelfuse, Inc. Specifications are subject to change without notice. Please refer to www.littelfuse.com/SPA for current information. Temperature TP Time °C 133 Revision: March 20, 2012 SP03A-3.3 Series TVS of Diode Arrays (SPA™ Family of Products) TVS Diode Arrays (SPA™ Family Products) Lightning Surge Protection - SP03A-3.3 Lightning SeriesSurge Protection - SP03-3.3 SP03A-3.3Series Series Package Dimensions — Mechanical Drawings and Recommended Solder Pad Outline Package SOIC Pins 8 JEDEC MS-012 o Recommended Soldering Pad Outline (Reference Only) Inches Min Max Min Max A 1.35 1.75 0.053 0.069 A1 0.10 0.25 0.004 0.010 A2 1.25 1.65 0.050 0.065 B 0.31 0.51 0.012 0.020 c 0.17 0.25 0.007 0.010 D 4.80 5.00 0.189 0.197 E 5.80 6.20 0.228 0.244 E1 3.80 4.00 0.150 0.157 e 1.27 BSC L 0.050 BSC 1.27 0.40 0.050 0.016 Embossed Carrier Tape & Reel Specification — SOIC Package Millimetres E G= Green 0.065 0.073 5.6 0.213 0.22 2.05 0.077 0.081 D 1.5 1.6 0.059 0.063 1.50 Min 3.9 4.1 40.0 +/- 0.20 0.059 Min 0.154 0.161 1.574 +/- 0.008 W 11.9 12.1 0.468 0.476 P 7.9 8.1 0.311 0.319 A0 6.3 6.5 0.248 0.256 B0 5.1 5.3 0.2 0.209 K0 2 2.2 0.079 0.087 0.30 +/- 0.05 0.012 +/- 0.002 Package B = SOIC Series Working Voltage Product Characteristics Part Marking System LF SP03A-3.3 XXXXXXXX Lead Plating Matte Tin Lead Material Copper Alloy Lead Coplanarity 0.004 inches (0.102mm) Substitute Material Silicon Body Material Molded Epoxy Flammability UL 94 V-0 First Line: Part number Second Line: Date code Ordering Information Part Number Package Marking Min. Order Qty. SP03A3.3BTG SOIC Tape & Reel SP03A-3.3 2500 SP03A-3.3 Series 1.85 5.4 t T= Tape & Reel Max 1.65 1.95 P0 Silicon Protection Array (SPATM) Family of TVS Diode Arrays Min F 10P0 SP 03A– 3.3 B T G Max P2 D1 Part Numbering System Inches Min Notes : 1. All dimensions are in millimeters 2. Dimensions include solder plating. 3. Dimensions are exclusive of mold flash & metal burr. 4. Blo is facing up for mold and facing down for trim/form, i.e. reverse trim/form. 5. Package surface matte finish VDI 11-13. 134 Revision: March 20, 2012 ©2012 Littelfuse, Inc. Specifications are subject to change without notice. Please refer to www.littelfuse.com/SPA for current information. SP03A-3.3 Millimetres LF