SFP-O3D-LR1 Datasheet

Optical Communications Systems™
Datasheet
155 Mbps Single-Mode 60 km SFP Transceivers
SFP-O3-LR1
Highlights
SFP transceiver
Data Rates: 155 Mbps
Protocols:
- SDH STM-1
- SONET OC-3
Single-mode fiber
1310 nm
20 to 60 km
Duplex LC connector
Digital Diagnostics (SFF-8472) on select models
Hot-swap
Industrial temperature models available
Overview
Small Form-Factor Pluggable (SFP) interfaces from MRV Communications provide flexible high speed links in a small
industry-standard package. They deliver the deployment options and inventory control that network administrators
demand for growing networks.
SFPs are designed to Multi-Source Agreement (MSA) standards to ensure network equipment compatibility. They are a
perfect addition to MRV ‘s extensive lines of networking equipment.
Visit the MRV website at www.mrv.com or contact your nearest authorized MRV Communications dealer for more
information.
Specifications Overview
Data Rate
155 Mbps
Tx Wavelength
1310 nm
Tx Power (Minimum)
-5 dBm
Dispersion Penalty
1 dB
Tx Disable
Yes
Rx Wavelength Range
1260 - 1580 nm
Rx Sensitivity
-34 dBm
Rx Saturation
-10 dBm
Operating Temperature Range
0 to 70 ºC
Operating Temperature Range (TH Models)
-40 to 85 ºC
Power Consumption
1 Watt
1
Optical Communications Systems™
Datasheet
Optical Specifications
Parameter
Symbol
Minimum
Maximum
Unit
Note
Transmitter
Center Wavelength
Average Output Power
Spectral Width (RMS)
Extinction Ratio
Jitter Generation (RMS)
Jitter Generation (pk-pk)
Optical Eye Mask
1263
1360
nm
λC
POUT
-5
0
dBm
3
nm
Δλ
EX
10
dB
0.01
UI
0.1
UI
Compliant with Telecordia GR-253-CORE and ITU-T G.957
1
2
Receiver
Center Wavelength
Receiver Sensitivity
Receiver Overload
Optical Path Penalty
LOS Assert
LOS De-Assert
LOS Hysteresis
Notes:
1.
2.
3.
4.
1260
-10
-45
1
λC
PIN
PIN
LOSA
LOSD
-
1580
-34
1
-37
4
nm
dBm
dBm
dB
dBm
dBm
dB
3
3
4
-
The optical power is launched into SMF.
Measured with a PRBS 223-1 test pattern @155 Mbps.
Measured with a PRBS 223-1 test pattern @155 Mbps, BER ≤1×10-10.
Measured with a PRBS 223-1 test pattern @155 Mbps, over 15km G.652 SMF, BER ≤1×10-10.
Monitoring Specifications
Parameter
Temperature
Voltage
Bias Current
Tx Pwer
Rx Power
Range
-40 to 95 ºC
3.0 to 3.6 V
0 to 100 mA
-6 to 1 dBm
-30 to -7 dBm
Accuracy
± 3 ºC
±3%
± 10 %
± 3 dB
± 3 dB
Calibration
External
External
External
External
External
Absolute Maximum Ratings*
Parameter
Maximum Supply Voltage
Operating Case Temperature
Operating Case Temperature (TH Models)
Storage Temperature
Relative Humidity (Non-Condensing)
Symbol
VCC
TC
TC
TS
RH
Minimum
-0.5
0
-40
-40
0
Maximum
3.6
70
85
85
95
Unit
V
ºC
ºC
ºC
%
Note
-
Maximum
70
85
3.47
300
1
155
Unit
ºC
ºC
V
mA
W
Mbps
Note
-
* Exceeding the limits listed in the table may damage the transceiver module permanently.
Recommended Operating Conditions
Parameter
Operating Case Temperature
Operating Case Temperature (TH Models)
Power Supply Voltage
Power Supply Current
Power Dissipation
Data Rate
Symbol
TC
TC
VCC
ICC
PD
DR
Minimum
0
-40
3.13
-
2
Optical Communications Systems™
Datasheet
Electrical Specifications
Parameter
Symbol
Minimum
Maximum
Unit
Note
VIN
ZIN
VD
VEN
-
500
90
2.0
GND
2.0
0
2400
110
Vcc
GND + 0.8
Vcc + 0.3
0.8
mV
Ω
V
V
V
V
1
-
V out
VLOS Fault
VLOS Normal
370
Vee
-
2000
Vcc + 0.3
GND + 0.8
mV
V
V
1
-
Note
Transmitter
Data Input Swing Differential
Input Differential Impedance
TxDisable_Disable
TxDisable_Enable
TxFault_Fault
TxFault_Normal
Receiver
Data Output Swing Differential
Rx_LOS Fault
Rx_LOS Normal
Notes:
1.
Internally AC coupled
Pin Descriptions
Notes:
Pin
Function
Name/Description
Plug Seq.
1
VeeT
Transmitter Ground
1
-
2
Tx Fault
Transmitter Fault Indication
3
1
3
Tx Disable
Transmitter Disable
3
2
4
MOD_DEF(2)
Module Definition 2
3
3
5
MOD_DEF(1)
Module Definition 1
3
3
6
MOD_DEF(0)
Module Definition 0
3
3
7
Rate Select
Not Connected
3
-
8
LOS
Loss of Signal Indication
3
4
9
VeeR
Receiver Ground
1
-
10
VeeR
Receiver Ground
1
-
11
VeeR
Receiver Ground
1
-
12
RD-
Inverted Received Data Out
3
5
13
RD+
Received Data Out
3
5
14
VeeR
Receiver Ground
1
-
15
VccR
Receiver Power
2
-
16
VccT
Transmitter Power
2
17
VeeT
Transmitter Ground
1
-
18
TD+
Transmitter Data In
3
6
19
TD-
Inverted Transmitter Data In
3
6
20
VeeT
Transmitter Ground
1
-
1.
2.
3.
4.
5.
6.
TX Fault is an open collector output, which should be pulled up with a 4.7 k~10 kΩ resistor on the host board to a voltage between 2.0 V and
Vcc+0.3V. Logic 0 indicates normal operation; logic 1 indicates a laser fault of some kind. In the low state, the output will be pulled to less than 0.8 V.
TX Disable is an input that is used to shut down the transmitter optical output. It is pulled up within the module with a 4.7 k~10 kΩ resistor.
Its states are:
Low (0~0.8 V):
Transmitter on
(>0.8V, <2.0V):
Undefined
High (2.0~3.465V):
Transmitter Disabled
Open:
Transmitter Disabled
MOD-DEF 0,1,2 are the module definition pins. They should be pulled up with a 4.7 k~10 kΩ resistor on the host board. The pull-up voltage shall be
VccT or VccR.
MOD-DEF 0 is grounded by the module to indicate that the module is present
MOD-DEF 1 is the clock line of two wires serial interface for serial ID
MOD-DEF 2 is the data line of two wires serial interface for serial ID
LOS is an open collector output, which should be pulled up with a 4.7 k~10 kΩ resistor on the host board to a voltage between 2.0 V and Vcc+0.3V.
Logic 0 indicates normal operation; logic 1 indicates loss of signal. In the low state, the output will be pulled to less than 0.8 V.
These are the differential receiver output. They are internally AC-coupled 100 Ω differential lines which should be terminated with 100 Ω
(differential) at the user SERDES.
These are the differential transmitter inputs. They are AC-coupled, differential lines with 100 Ω differential termination inside the module.
3
Optical Communications Systems™
Datasheet
Mechanical Dimensions
Connector
Bail Latch
Color
SDH STM-1, SONET OC-3 SFP Transceiver
155
Duplex LC
Grey
No
20 - 60
SFP-O3D-LR1
SDH STM-1, SONET OC-3 SFP Transceiver
155
Duplex LC
Grey
Yes
20 - 60
SFP-O3-LR1TH
SDH STM-1, SONET OC-3 SFP Transceiver,
Temperature Hardened
155
Duplex LC
Grey
No
20 - 60
SFP-O3D-LR1TH
SDH STM-1, SONET OC-3 SFP Transceiver,
Temperature Hardened
155
Duplex LC
Grey
Yes
20 - 60
Maximum
Distance
Range
(km)*
Data Rate
(Mbps)
SFP-O3-LR1
Model
Description
Digital
Diagnostics
Ordering Information
* Maximum range quoted is not possible with all wavelength and/or fiber. Please consult MRV.
Regulatory and Industry Compliances
Class 1 Laser Product, complies with EN 60825-1 and 21 CFR 1040.10 except for deviations pursuant to Laser Notice No. 50. dated June 24, 2007
MSA SFF-8074i; Digital Diagnostic SFF-8472
Certified by one or more of the following agencies: TÜV, UL, CSA
RoHS Directive; China RoHS; California RoHS Law, REACH Directive SVHC; WEEE Directive
The Quality Management System is certified to ISO 9001 by QMI-SAI Global
The Environmental Management System is in compliance with ISO 14001
Warnings
Handling Precautions: This device is susceptible to damage as a result of electrostatic descharge (ESD). A static free environment is highly
recommended. Follow guidelines according to proper ESD procedures.
Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation.
MRV has more than 50 offices throughout the world. Addresses, phone numbers and fax numbers are listed at www.mrv.com.
Please e-mail us at [email protected] or call us for assistance.
MRV Los Angeles
20415 Nordhoff Street
Chatsworth, CA 91311
800-338-5316
818-773-0900
MRV Boston
300 Apollo Drive
Chelmsford, MA 01824
800-338-5316
978-674-6800
MRV International
Business Park Moerfelden
Waldeckerstrasse 13
64546 Moerfelden-Walldorf
Germany
Tel. (49) 6105/2070
Fax (49) 6105/207-100
All statements, technical information, and recommendations related to the products herein are based upon information believed to be reliable or accurate. However, the
accuracy or completeness thereof is not guaranteed, and no responsibility is assumed for any inaccuracies. Please contact MRV Communications for more information.
MRV Communications and the MRV Communications logo are trademarks of MRV Communications, Inc. Other trademarks are the property of their respective holders.
MRV-OP-SFPO3DLR1-082410
3020084-001 Rev. A2
Copyright ©2010 MRV Communications, Inc. All Rights Reserved.