Harwin Test Report Summary HT01201 Mechanical Testing of Datamate (M80 Series) L-Tek Horizontal Male SMT Contacts HT01201 Test Report for Datamate Male Horizontal SMT L-Tek Mechanical Testing 1. Introduction. 1.1. Description and Purpose. The Harwin Datamate (M80 Series) connector is manufactured to the requirements of BS9525F0033. The following tests were carried out to confirm that the new design of stamped contacts for use in Datamate L-Tek Male Horizontal SMT connectors would be comparable with the rest of the range for contact retention. The results of testing to confirm insertion force, withdrawal force and contact resistance in L-Tek can be read over from the J-Tek results, documented in Harwin Test Summary HT010XX. 1.2. Conclusion. The following test data has been taken from Harwin test report C41/06. Both stamped contacts easily met the required standards, and are therefore approved for use as Datamate contacts. 2. Test Method, Requirements and Results. 2.1. List of Test Samples. a) M80-6650442 4-way male Horizontal SMT J-Tek connector, incorporating stamped contacts M80-2340042 and M80-2350042 b) M80-6652042 20-way male Horizontal SMT J-Tek connector, incorporating stamped contacts M80-2340042 and M80-2350042 c) M80-6653442 34-way male Horizontal SMT J-Tek connector, incorporating stamped contacts M80-2340042 and M80-2350042 2.2. Specification Parameters. The BS9525-F0033 requirement for contact retention within a moulding is 10N minimum. 2.3. Results. M80-6650442 Contact Minimum Maximum Average M80-6652042 M80-6653442 M80-2340042 M80-2350042 M80-2340042 M80-2350042 M80-2340042 M80-2350042 17.98N 19.69N 18.55N 15.40N 17.80N 16.60N 15.21N 18.88N 16.26N 11.32N 17.52N 14.46N 15.60N 22.93N 19.38N 13.68N 21.00N 18.14N Harwin North America T: +1 603 893 5376 F: +1 603 893 5396 E: [email protected] W: www.harwin.com Issue: 1 Date: 20/10/2011 C/Note: ----- Harwin Europe T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 Harwin Asia T: +65 6 779 4909 F: +65 6 779 386 E: [email protected] W: www.harwin.com E: [email protected] W: www.harwinasia.com Page 2 of 2