MDA920A1 thru MDA920A9 - New Jersey Semiconductor

<cyv
20 STERN AVE.
SPRINGFIELD, NEW JERSEY 07081
U.S.A.
TELEPHONE: (973) 376-2922
(212)227-6005
FAX: (973) 376-8960
MDA920A1
thru
MDA920A9
si Sheet
MINIATURE INTEGRAL DIODE ASSEMBLIES
SINGLE-PHASE
FULL-WAVE BRIDGE
. . . passivated, diffused-silicon dice interconnected and transfer
molded into void less hybrid rectifier circuit assemblies.
1.5 AMPERES
•
Large Inrush Surge Capability — 45 A (For
•
Efficient Thermal Management Provides Maximum Power Handling
in Minimum Space
Designers Data for "Worst Caw"
1.0 Cycle)
25-1000 VOLTS
Conditions
The Designers Datasheet permits the design of most circuits entirely from
the information presented. Limit curves - representing boundaries on device
characteristics - are given to facilitate "worst case" design.
MAXIMUM RATINGS
Rating (Par Lag)
Symbol
Peak Repetitive Reverse Voltage
Working Peak Reverse Voltage
VRRM
V RWM
A9
Unit
25 50 1OO 200 300 400 600 800 1000
Volts
A1 A2 A3 A4 AS A6 A7 AS
DC Blocking Voltage
VR
DC Output Voltage
Resistive Load
Capaciuttve Load
Vdc
Vdc
15 30 62 124 185 250 380 500 620 Volts
25 SO 100 200 300 400 600 800 1000 Volts
VR(RMS)
18 35 70 140 210 280 420 560 700 Volts
Sine Wave RMS Input Voltage
Average Rectified Forward
Current
(single phase bridge
resistive load, 60 Hz,
see Figure 6. TA - SO°C
Non-Repetitive Peak Surge
Current, (see Figure 21
rated load.Tj = 175°C
Operating and Storage Junction
Temperature Range
Amp
'0
'FSM
-•
Am[
45 for 1 cycl<
°C
510*175
Tj. Tltg
r
NOTES:
1.LEAD DIM "0"TQ BE
MEASURED WITHIN "I"
ELECTRICAL CHARACTERISTICS
Characteristic
Maximum Instantaneous Forward Voltage Drop
(Per Legl lip - 2-4 Amp, Tj - 25°CI Figure 1
Maximum Revere* Current (Rated dc Voltage
across ac terminals, Tj « 25°CJ
Symbol
Max
Unit
VF
1.2
Volts
|R
20
CA
THERMAL CHARACTERISTICS
I. LEADS FORMED TO f IT INTO
HOLE 0.94 mm BH37IMIN.
INCHES
Symbol
Character istic
Effective Bridge Thermal Resistance,
Junction to Ambient (Full-Wave Bridge Operation,
Typical Printed Circuit Board Mounting)
Unit
50
°C/W
woo
1.T40
MECHANICAL CHARACTERISTICS
CASE: Transfer-molded plastic encapsulation.
POLARITY: Terminal-designation embossed
on case
+DC output
-DC output
•vAC input
MOUNTING POSITION: Any
WEIGHT: t.Ogram (approx)
TERMINALS: Readily solderable
connections, corrosion resistant.
NJ Semi-Conductors reserves the right to change test conditions, parameter limits and package dimensions with in
notice. Information furnished by NJ Semi-Conductors is believed to.be both accurate and reliable at the time u. go'ing
to press. However, NJ Semi-Conductors assumes no responsibility for any errors or omissions discovered in its use.
NJ Semi-Conductors encourages customers to verify that datasheets are current before placing orders.
Quality Semi-Conductors