DC-DC Converter DIP-Package DNV-15 SERIES, 15WATT, 2:1 INPUT RANGE FEATURES: 1500Vac isolation voltage Six-side shielded metal case with low ripple and noise Over voltage, over current, short circuit protection Operating temperature range -40 3 year warranty ℃ to +85℃ Output voltage (Vdc) Output current (mA) Efficiency Typ. DNV15-1211 3.3 4000 85% DNV15-1212 5.1 3000 87% 12.1 1200 87% DNV15-1214 15.1 1000 89% DNV15-1215 24.2 800 89% DNV15-2411 3.3 4000 87% DNV15-2412 5.1 3000 89% 12.1 1200 89% DNV15-2414 15.1 1000 90% DNV15-2415 24.2 800 90% DNV15-4811 3.3 4000 87% DNV15-4812 DNV15-4813 DNV15-4814 DNV15-4815 5.1 3000 89% 12.1 1200 89% 15.1 1000 90% 24.2 800 90% 5.1 3000 89% 12.1 1200 89% 15.1 1000 90% 24.2 800 90% Model DNV15-1213 DNV15-2413 Input voltage (Vdc) 12(9~18) 24(18~36) 48(36~72) DNV15-11012 DNV15-11013 DNV15-11014 110(66~160) DNV15-11015 Notes: 1.Other input and output models may available on request; 2.You may request for the models with heatsink, plus “R” in the suffix, e.g. DNV15-1211R. ELECTRICAL Output voltage accuracy --- Line regulation Nominal Load, full voltage ±0.2% max. Load regulation 20% ~ 100% rated load ±0.5% max. Dynamic response (transient/recovery time) www.pairuigroup.com ≤1% 5%-50%-75% load capability Page: 1 / 4 ∆Vo/∆t: ±5.0%/500μs Date: 07/30/2015 * Subject to change without notice DC-DC Converter DIP-Package DNV-15 SERIES, 15WATT, 2:1 INPUT RANGE ELECTRICAL Ripple and noise 20MHz BM, full load Isolation voltage (<2mA/min) 1% Vout max. Input to output 1500Vac Input to case 1000Vac Output to case 500Vac Isolation resistance 500Vdc 20MΩ Temperature coefficient --- Operating temperature range Auxiliary heat sink Storage temperature range --- -45℃ to +120℃ Over current protection --- Auto-recovery Short circuit protection --- Continuous auto-recovery Over voltage protection --- Auto-recovery Relative humidity --- 10%-90% max. Conducted emission --- CLASS A MTBF Bellcore TR-332, 25℃ 200KHrs Weight With heatsink ±0.02%/℃ max. -40℃ to +85℃ 30g Notes: All the parameters are measured at 25℃ ambient temperature, humidity < 75%, nominal input voltage, full load and after warm-up, unless otherwise specified. MECHANICAL WITHOUT HEATSINK www.pairuigroup.com WITH HEATSINK Page: 2 / 4 Date: 07/30/2015 * Subject to change without notice DC-DC Converter DIP-Package DNV-15 SERIES, 15WATT, 2:1 INPUT RANGE MECHANICAL CONNECTION PCB LAYOUT PIN # SINGLE 1 +Vin 2 -Vin 3 +Vo 4 No Pin 5 GND Note: * Unit is mm(inch). TEMPERATURE PROFILE CAPACITIVE LOADS SELECTION Vout: 3.3V 5V Vout: 12V 5V Vout: 24V Recommended MAX. Recommended MAX. Recommended MAX. value value value value value value 10000μF 15000μF 1000μF 2200μF 470μF 1000μF www.pairuigroup.com Page: 3 / 4 Date: 07/30/2015 * Subject to change without notice DC-DC Converter DIP-Package DNV-15 SERIES, 15WATT, 2:1 INPUT RANGE NOTES RECOMMENDED TEST AND APPLICATION CIRCUIT 1, TVS&FUSE be helpful with over voltage protection and inrush limiting. Recommended FUSE better be 1.5~2times of the rated current . 2, The input filter capacitor C6 could select the aluminum electrolytic capacitors or tantalum capacitors, and the withstand voltage should be greater than the highest input voltage. Recommended capacitor should be between 22μF~100μF. 3, C1,C2 for the input filter capacitor,0.1~1μF high-frequency ceramics capacitor or chip capacitor are recommended. The withstand voltage of output filter C5, C7 should be greater than the highest output voltage. Recommended capacitor of C7 better within 100μF and C5 connected with the chip to reduce the input voltage peak, recommended 0.1~1μF high-frequency ceramics capacitor or chip capacitor. www.pairuigroup.com Page: 4 / 4 Date: 07/30/2015 * Subject to change without notice