Xeon 3 Power 850nm Infrared Emitter LED OSI3XNE3E1E VER C.0 ■Features ■Outline ● Highest luminous flux ● Super energy efficiency ● Very long operating life ● Superior ESD protection Dimension ■Applications Night Vision ● Camera ● Outdoor./Indoor applications ■Absolute Anode Cathode Unit:mm Tolerance:±0.30mm ℃ (Ta=25 ) Maximum Rating Item ■Directivity Symbol Value Unit DC Forward Current IF 1000 mA Pulse Forward Current* IFP 2000 mA Reverse Voltage VR 5 V Power Dissipation PD 2000 mW Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40~ +100 Lead Soldering Temperature Tsol 260 *Pulse width Max.10ms ■Electrical - ℃ (Ta=25 ) -Optical Characteristics Item Symbol Condition Min. Typ. DC Forward Voltage VF IF=700mA - 1.7 0 ℃ ℃ ℃/5sec Duty ratio max 1/10 0 Max. ■Forward Operating Unit 2.0 V DC Reverse Current IR VR=5V - - 10 µA Peak Wavelength λP IF=700mA - 850 - nm Radiant Power PO IF=700mA 200 250 - mW 2θ1/2 IF=700mA - 140 - deg 1000 Note: Don’t drive at rated current more than 5s without heat sink for Xeon 3 emitter series. LED & Application Technologies Rth(J-a)=20℃/W 800 Rth(J-a)=30℃/W 600 Rth(J-a)=40℃/W 400 200 0 0 50% Power Angle Current (DC) 1200 Forward Current, IF (mA) ● 20 40 60 Ambient Temperature, TA ( 80 ) 100 Xeon 3 Power 850nm Infrared Emitter LED OSI3XNE3E1E VER C.0 ■ Soldering Heat Reliability : Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Solder Average ramp-up rate = 3ºC/sec. max. Preheat temperature: 150º~180ºC Preheat time = 120 sec. max. Ramp-down rate = 6ºC/sec. max. Peak temperature = 220ºC max. Time within 3ºC of actual peak temperature = 25 sec. max. Duration above 200ºC is 40 sec. max. LED & Application Technologies