Model MM4xMS-1 Model MM4xMS-14 Triple Balanced Mixer RF 1.5 to 9.0 GHz Multi-Octave Band Electrical Specifications: Parameter SSB Conversion loss: (2) (3) Isolation LO to RF: LO to IF: RF to IF: (1) Specifications Conditions RF (GHz) 2.0-9.0 1.5-9.0 LO (GHz) 2.0-9.0 1.5-9.0 1.5-3.0 3.0-9.0 1.5-9.0 IF (MHz) 10-3000 10-4000 Min 15 dB 20 dB 22 dB 1.5-9.0 Typical 8.0 dB 7.3 dB 18 28 32 27 Max 9.0 dB 9.5 dB Model MM4xMS-1 Model MM4xMS-14 dB dB dB dB Input 1 dB Compression Point: 1.5-9.0 1.5-9.0 10-4000 +5 dBm +8 dBm +12 dBm +15 dBm MM44 MM46 MM47 MM48 Input Third Order Intercept Point: 1.5-9.0 1.5-9.0 10-4000 +14 +17 +21 +24 dBm dBm dBm dBm MM44 MM46 MM47 MM48 LO Power: (4) 1.5-9.0 1.5-9.0 10-4000 +10 +13 +17 +21 dBm dBm dBm dBm MM44 MM46 MM47 MM48 LO Power 4 = +10 dBm 6 = +13 dBm 7 = +17 dBm 8 = +21 dBm Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25˚C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within ±0.5 dB of conversion loss for IF frequencies greater than 10 MHz. 3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -54˚C. 4. Usable LO drives are up to 2 dB below and 3 dB above nominal. MM4xMS-1 Outline: MS2A Typical Performance at 25˚C RF to IF Isolation - dB z MM4xMS-14 Outline: MS2B Relative Conv. Loss vs. IF Freq.-dB All dimensions are in inches and [mm]. CT Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, FL 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, PA 19154 · PH (215) 464-4000 · Fax (215) 464-4001 REV B 5/24/10