Toggles Series SS Ultra-Miniature Illuminated Slides Rockers Distinctive Characteristics Pushbuttons Top or side actuation permits flexible board design. Programmable Illuminated PB Bright, LED illumination at tip of actuator. Compact dimensions and low profile allow high density mounting and close stacking of PC boards. Keylocks Crisp actuation positively indicates circuit status. H Tactiles Sliding twin contact mechanism with self-cleaning action provides smooth actuation and produces high contact reliability. Slides Rotaries Double molded thermoset base and thermoplastic housing prevent loosening of terminals due to high soldering temperatures. Tilt Insert molded terminals lock out flux, solvents, and other contaminants. Touch Inch terminal spacing for standard PC board grid (.100” x .100”). Supplement Accessories Indicators Actual Size www.nkk.com H49 Toggles Series SS Rockers General Specifications Electrical Capacity (Resistive Load) Pushbuttons Power Level: Other Ratings Programmable Illuminated PB Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Contact Timing: Total Travel: Materials & Finishes Rotaries Keylocks Actuator: Upper Case: Lower Case: Movable Contactor: Interior Base: Terminals: Tactiles Slides Environmental Data H Operating Temp Range: Humidity: Vibration: Shock: Touch Tilt PCB Processing Soldering: Cleaning: 0.1A @ 30V DC 20 milliohms maximum 100 megohms minimum @ 500V DC 500V AC minimum 1 minute minimum 10,000 operations minimum 10,000 operations minimum Shorting (make-before-break) .079” (2.0mm) Polyacetal Polyacetal Glass fiber reinforced polyester Phosphor bronze with silver plating Phenolic resin (thermoset) Brass with silver plating over copper plating –15°C through +60°C (+5°F through +140°F) 90 ~ 95% humidity for 96 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Wave Soldering: For non-supported through-hole, see Profile B in Supplement section. For supported through-hole, 5 seconds maximum @ 250°C maximum. Manual Soldering: See Profile B in Supplement section. These devices are not process sealed. Hand clean locally using alcohol based solution. Standards & Certifications The SS series devices have not been tested for UL recognition and CSA certification. These switches are designed for use in a low-voltage, low-current circuit. When used as intended in a low-voltage, low-current circuit, the results do not produce hazardous energy. Supplement Accessories Indicators Ultra-Miniature Illuminated Slides H50 www.nkk.com Series SS Toggles Ultra-Miniature Illuminated Slides P Poles & Circuits 2 L C LED Colors Actuation 12S SPDT ON NONE ON P Top Actuated C Red 22S DPDT ON NONE ON H Side Actuated E Yellow F Green D Contact Material & Ratings Inch .100” x .100” LED Circuit L Isolated Keylocks Terminal Spacing Pushbuttons D Programmable Illuminated PB 12S Silver Rated 0.1A @ 30V DC 2 Rotaries DESCRIPTION FOR TYPICAL ORDERING EXAMPLE SS12SDP2LC Red LED Top Actuated SPDT ON-NONE-ON Circuit Silver Contacts Rated 0.1A @ 30V DC H Slides SS Rockers TYPICAL SWITCH ORDERING EXAMPLE Tactiles Terminals with .100” Spacing POLES & CIRCUITS Model SP SS12S Center Left Right Center Left ON NONE ON 2-1 NONE 2-3 Note: Terminal numbers are not actually on switch. Isolated LED circuit requires external power source. SPDT 3 DP SS22S ON NONE ON 2-1 5-4 NONE 2-3 5-6 2 (COM) DPDT 1 2 (COM) 3 4 (+) (-) (+) (-) 1 5 (COM) 6 Single Pole Models (0.4) Typ .016 (2.54) Typ .100 (3.4) Typ .134 (9.0) .354 (0.4) Typ .016 (2.54) Typ .100 (0.6) Typ .024 (13.0) .512 (2.54) Typ .100 (3.4) Typ .134 Double Pole Models www.nkk.com (9.0) .354 (2.54) Typ .100 (0.6) Typ .024 Supplement Inch .100” x .100” Accessories TERMINAL SPACING D Tilt Right Throw & Schematics Touch Pole Connected Terminals Indicators Slide Position (13.0) .512 H51 Series SS Toggles Ultra-Miniature Illuminated Slides CONTACT MATERIALS & RATINGS Rockers 2 Silver over Phosphor Bronze Power Level 0.1A @ 30V DC TYPICAL SWITCH DIMENSIONS Pushbuttons Single & Double Pole Top Actuated (2.54) .100 L (+) Programmable Illuminated PB (2.0) Travel .079 (0.4) .016 (2.54) .100 (0.6) Typ .024 (0.3) Typ .012 1 (13.0) .512 L (-) 3 (2.54) Typ .100 (3.0) .118 (2.5) .098 (2.5) .098 (3.7) .146 (9.0) .354 2 (2.54) Typ .100 L (+) 1 2 (0.3) Typ .012 L (+) L (-) (0.6) Typ .024 (0.4) Typ .016 (4.5) .177 (0.8) Dia Typ .031 (13.0) .512 6 (2.54) Typ .100 (0.6) Typ .024 (0.4) Typ .016 4 L (+) 1 5 2 6 L (-) 3 Keylocks Side Actuated (2.54) .100 L (+) (3.7) .146 Rotaries Slides (2.54) .100 (0.6) Typ .024 (0.4) .016 (0.3) Typ .012 1 3 1 (13.0) .512 H L (+) 4 L (-) 6 3 2 (0.8) Dia Typ .031 (2.54) Typ .100 (2.5) .098 (0.6) Typ .024 (0.4) Typ .016 (7.5) .295 (3.0) .118 (0.6) Typ .024 (4.5) .177 (9.0) .354 4 L (+) 1 5 2 6 L (-) 3 Tactiles Tilt (2.54) Typ .100 (0.8) Dia Typ .031 SS12SDH2LC LED COLORS & SPECIFICATIONS LEDs are supplied as an integral part of the switch (not available separately). The lamp circuit is independent of switch operation. Electrical specifications shown are determined at a basic temperature of 25°C. If the source voltage exceeds the rated voltage, a ballast resistor is required. The resistor value can be calculated by using the formula given in the Supplement. L Isolated, 1-element (+) (-) Color C E Red Yellow 30mA 30mA 25mA Typical Forward Current IF 16mA 16mA 16mA Forward Voltage VF 1.98V 2.06V 2.16V Reverse Peak Voltage VRM 5V 5V 5V Current Reduction Rate Above 25°C ∆IF 0.40mA/°C 0.42mA/°C 0.33mA/°C Ambient Temperature Range AT4065 Slide Cap Cap can be assembled on request Cap Color: Black only H52 Green IFM –15° ~ +60°C OPTIONAL CAP Material: Polycarbonate F Forward Peak Current Indicators Touch (2.54) Typ .100 3 L (-) (13.0) .512 5 2 1 (2.54) Typ .100 (4.85) .191 (7.5) .295 L (-) (0.4) Typ (0.3) Typ .016 .012 (2.54) Typ .100 L (+) 2 (2.5) .098 Accessories SS22SDP2LC Single & Double Pole (2.0) Travel .079 Supplement (2.54) Typ .100 (0.8) Dia Typ .031 (2.54) Typ .100 3 L (-) 4 5 2 3 1 (3.2) .126 (5.0) .197 (5.0) .197 (11.0) .433 (8.5) .335 (0.6) .024 www.nkk.com Window color should match LED color. Colors Available: C Red E Yellow F Green