BOGEY-BOARD-868 Turns any switch into a remote control! Features: Simple to use Range up to 100m 4 digital inputs Ultra low power Versatile Auto-transmit fail safe option Compact - 38mm x 42mm Operates with: BRAVO-T868 ELITE Series Applications Remote Control Remote Networking Remote Switching Remote Traffic Lights Door bells / Buzzers Push buttons The BOGEY-BOARD is an innovative product which allows anybody to make their own remote transmitter and wireless enable an existing switch. With 4 close contact inputs to use and being only 38mm x 42mm the BOGEY-BOARD is small and powerful. The tiny board is easily capable of achieving 100m range in open line-of-sight conditions. Ordering Information: Part number: BOGEY-BOARD-868 BOGEY-BOARD functional overview: BOGEY-BOARD is supplied with a small wire antenna using this it is possible to achieve up to 150m range. NOTE: An antenna ground point is also provided for those wishing to change the antenna* Transmit type select Closed: Latching switch Open: – Momentary switch BOGEY-BOARD has four inputs. Each requires a volt free switch in order to operate. TIP: Minimise the length of wires between the board and your switch *Whilst BOGEY-BOARD is supplied with a battery connector for use with a 9V PP3 battery, it is designed to operate using any voltage may be applied between 4.5Vdc and 12Vdc 4.5Vdc – 12Vdc LEDs: Green – Transmit Red – Ack fail Operational Characteristics The BOGEY-BOARD is very simple to connect and use. Wire a switch to any one or many of the inputs and close the contact send a signal. As default the BOGEY-BOARD is designed for use with momentary buttons - to send a signal continuously while a button is pressed. As such it will replicate a handheld transmitter. Transmit type select: Latching button operation: The BOGEY-BOARD can be configured to work with a latching push button, where by it will send a signal only each time the input changes its status - it sends three packets when a switch is closed and three more when it is opened. Latching button is enabled the BOGEY-BOARD will request an acknowledgement from any receiver it is paired to after a transmission. If no ack is received then the BOGEY-BAORD will re-try. After 3 failed attempts it will flash its red LED 10 times. Momentary button operation: The BOGEY-BOARD can operate with momentary push switches. In this mode it will send data continuously while an button is closed over its input. LEDs Green LED: Flashes as each transmission is sent RED LED: Shows a failed transmission in request acknowledge mode. Indicates LOW BATTERY - flashes slowly. *Soldering to or otherwise modifying the BOGEY-BOARD will invalidate the warranty. Compatible receivers: The BOGEY-BAORD is a versatile remote control and as such is compatible with nearly all RF Solutions 868MHz receivers. Receiver Part Number Form Factor Expected Range Outputs ELITE-RX Boxed IP rated 100m 4 230Vac outputs ELITE-RXL Boxed IP rated 100m 4 changeover relays BRAVO-T868 Intelligent radio module 100m 4 TTL level Mechanical Drawing: 38.00 29.00 9.00 1.00 11.00 42.00 4.00 Max Height @ Screw Terminals 16.00 Ø3.00m Technical Specifications: Operating temperature: 0 - 55oC Storage Temperature: -10 - 70oC Electrical Characteristics Min Typical Max Units Supply Voltage: 4.5V-12V Supply 4.5 9 12 Vdc Antenna Output Lead Impedance 50 Ohms Minimum input activation time to trigger transmission 50 ms 868MHz Version Supply Current: Quiescent 4 6 8 uA Supply Current: Transmitting Data 18 22 26 mA Information contained in this document is believed to be accurate, however no representation or warranty is given and R.F. Solutions Ltd. assumes no liability with respect to the accuracy of such information. Use of R.F.Solutions’ products as critical components and or in life support systems is not authorised except with express written approval from R.F.Solutions Ltd.