BOGEYBOARD-433 Turns any switch into a remote control! Features: Simple to use Range up to 100m 4 digital inputs Ultra low power Versatile Compact - 38mm x 42mm Applications Remote Control Operates with: RDF1 HORNET-RX Remote Networking Remote Switching Remote Traffic Lights Door bells / Buzzers Push buttons 200 series - DIN RAIL The BOGEYBOARD is an innovative product which allows anybody to make their own remote transmitter and wireless enable an existing switch. With 4 close contact inputs to use and being only 38mm x 42mm the BOGEYBOARD is small and powerful. The tiny board is easily capable of achieving 100m range in open line-of-sight conditions. Ordering Information: Part number: BOGEYBOARD-433 BOGEYBOARD-433-1 Revision 1 August 2014 BOGEYBOARD functional overview: BOGEYBOARD has four inputs. Each requires a volt free switch in order to operate. TIP: Minimise the length of wires between the board and your switch. 4.5Vdc – 12Vdc RED Transmit indicator LED BOGEYBOARD is supplied with a small wire antenna using this it is possible to achieve up to 100m range. NOTE: An antenna ground point is also provided for those wishing to change the antenna* *Whilst BOGEYBOARD is supplied with a battery connector for use with a 9V PP3 battery, it is designed to operate using any voltage may be applied between 4.5Vdc and 12Vdc. Operational Characteristics The BOGEYBOARD is very simple to connect and use. Simply wire a switch to any one or many of the inputs and close the contact send a signal. IMPORTANT NOTE: As default the BOGEYBOARD is designed for use with momentary push buttons - to send a signal continuously while a button is pressed, and as such it will replicate a handheld transmitter. DO NOT use latching type switches which will cause it to transmit continuously and may block other signals. *Soldering to or otherwise modifying the BOGEY-BOARD will invalidate the warranty. BOGEYBOARD-433-1 Revision 1 August 2014 Compatible receivers: The BOGEYBOARD is a versatile remote control and as such is compatible with nearly all RF Solutions 433MHz receivers. Receiver Part Number Form Factor Expected Range Outputs HORNET-RX Boxed IP rated 100m 4 Relays RDF1 Intelligent radio module 100m 4 LVTTL level 210-433F DIN rail receiver 100m Up to 16 -(requires relay board) RF803 Decoder IC Dependent on receiver module 3 LVTTL level outputs Mechanical Drawing: 38.00 29.00 9.00 1.00 11.00 42.00 4.00 Max Height @ Screw Terminals 16.00 Ø3.00m BOGEYBOARD-433-1 Revision 1 August 2014 Technical Specifications: Operating temperature: 0 - 55oC Storage Temperature: -10 - 70oC Electrical Characteristics Min Typical Max Units Supply Voltage: 4.5V-12V Supply 4.5 9 12 Vdc Antenna Output Lead Impedance 50 Ohms Minimum input activation time to trigger transmission 50 ms 433MHz Version Supply Current: Quiescent 4uA 6uA 8uA uA Supply Current: Transmitting Data 18 22 26 mA Information contained in this document is believed to be accurate, however no representation or warranty is given and R.F. Solutions Ltd. assumes no liability with respect to the accuracy of such information. Use of R.F.Solutions’ products as critical components and or in life support systems is not authorised except with express written approval from R.F.Solutions Ltd. RF Solutions Ltd. Recycling Notice Meets the following EC Directives: DO NOT Discard with normal waste, please recycle. ROHS Directive 2002/95/EC Specifies certain limits for hazardous substances. WEEE Directive 2002/96/EC Waste electrical & electronic equipment. This product must be disposed of through a licensed WEEE collection point. RF Solutions Ltd., fulfils its WEEE obligations by membership of an approved compliance scheme. Waste Batteries and Accumulators Directive 2006/66/EC Where batteries are fitted, before recycling the product, the batteries must be removed and disposed of at a licensed collection point. Environment Agency producer registration number: WEE/JB0104WV.