FIGURE 1: SCHEMATIC DIAGRAM TABLE 1: ELECTRICAL SPECIFICATIONS AT 25 OC PARAMETER MIN. PRIMARY INDUCTANCE: (1-3) 0.40 Vrms @ 100 KHz 415 1 SPEC LIMITS TYP. M AX. 425 UNITS 435.8 PRIMARY H 3 FL1 SHIELD PRIMARY LEAKAGE IND. (1-3). 0.40Vrms @ 100 KHz. -------- -------- 3.0 H NC 4 TURNS RATIOS: 1-3 : FL1-FL2 1-3 : 4-5 --------------- 5.6 : 1 9.3 : 1 ----------------- +/-4% +/-4% RESONANT FREQUENCY (1-3) 1200 -------- -------- KHz -------- -------- Vrms HI-POT: 60 Hz at 1 sec. PRIMARY to SECONDARY. 3000 SECONDARY FL2 BIAS 5 FIGURE 2: PHYSICAL DIMENSIONS FL1 FL2 Apply Tape on this side of Core set to insulate SECONDARY leads. P M POL-JX014 YYWW CORE CLIP, 2EA WHITE DOT DENOTES PIN#1 SIDE OF BOBBIN 1 2 3 4 5 27.0 Max. 29.0 Max. 19.5 Max. 6.0 +/-0.5 3.50 Notes: 1) Design to comply with the requirements of UL/ CSA/IEC 60950-1. 2) Design to comply with the requirements of UL/ CSA/IEC Class B insulation system. 3) All materials per Premier Magnetics UL file #E177139. 4) All units comply wiht the requirments of the EU RoHS Directive. 5) Remove Bobbin terminal pin #2. 0.7 0.80 Dia, 50.0 REV. 06/03/13 DESCRIPTION OF CHANGES Original Release. RoHS UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN mm. DIMENSIONAL TOLERANCES ARE: DECIMALS ANGLES .X + 0.2 + 0 O 30' .XX + 0.30 DRAW ING NOT TO SCALE. INDUCTOR CONTROL DRAWING PREMIER P/N: POL-JX014 REVISION: 06/03/13 ENG: PETER PHAM REF: TOP269EG QA: Kevin Clark SHEET: 1 OF 1 BY KC