FIGURE 1: SCHEMATIC DIAGRAM TABLE 1: ELECTRICAL SPECIFICATIONS AT 25 OC PARAMETER MIN. TURNS RATIO'S: 1-3 : 6-4 ------- SPEC LIMITS TYP. MAX. UNITS 1 1:1 PRIMARY INDUCTANCE (1-3) VOLTAGE = 0.200Vrms @ 100KHz 560 700 DCR EACH WINDING -------- -------- -------- + 2% 840 Hy 2.0 PRIMARY 6 SECONDARY Ohm 4 3 LEAKAGE INDUCTANCE -------- 3.0 -------- Hy HI-POT: BETWEEN PRI & SEC 1250 -------- -------- Vdc FIGURE 2: PHYSICAL DIMENSIONS IN INCHES, (mm) 6 P M 5 4 FIGURE 3: PCB LAYOUT .059 (1.5) PMGD-63 YYWW .043 (1.1) PIN #1 (Dot) 1 .22 (5.6) 2 .073 (1.85) 3 .270 (6.86) MAX .250 (6.35) MAX .010 (0.25) .024 (0.6) .334 (8.5) MAX UNLESS OTHERW ISE SPECIFIED DIMENSIONS ARE IN INCHES DIMENSIONAL TOLERANCES ARE: DECIMALS ANGLES .XX + .04 + 0 O 30' .XXX + .020 DO NOT SCALE DRAWING REV. DESCRIPTION OF CHANGES BY 08/04/11 08/25/11 ORIGINAL RELEASE CHANGED INDUCTANCE PP PP GATE DRIVE TRANSFORMER CONTROL DRAWING PREMIER P/N: PMGD-63 REVISION: 08/25/11 ENGR: PETER PHAM REF: QA: KEVIN CLARK SHEET: 1 OF 1